This allows <bsd.lib.mk> to correctly set the RPATH of libraries that
use USE_SHLIBDIR=yes to /lib, so that dependent libraries can be found
from /lib when /usr/lib isn't mounted yet.
This was the intention of the _LIBLDOPTS support in <bsd.lib.mk>.
Fixes problem reported by Dan Carosone with when /sbin/cgdconfig is
dynamically linked against libcrypto.so but not libcrypt.so (it was
relying upon libcrypto.so to pull in libcrypt.so).
- TSO support.
- fix some error handling.
- remove mysterious RTK_NTXSEGS and use more appropriate values
for bus_dmamap_create.
- if we need more than all of our tx descriptors in order to transmit a packet,
just drop it rather than retrying infinitely.
character set maps:
A number of Code Pages specify a 8bit character mapping, but use
16bit runes, ma king them inaccessible for the actual conversion.
Similiary do some Code Pages specify an invalid rune e.g. of 0x00,
which is actually used in the mapping table and makes that rune
mapping invalid.
1) After setting an input or output channel to pause, watch for DCH (DMA
halted) to be set before resetting the registers. The manual says this is
required. This *may* fix random auich lockups.
2) Add auich_{trigger,intr,halt}_pipe(), which can operate on any of the
input and output channels. This reduces code duplication quite a bit.
While I'm at it, fill in the mic interrupt handling.
3) The mic in interrupt is MINT, not MIINT. (The latter is modem input.)
- Add xen devices to MAKEDEV
- Add Xen kernels to list of kernel to build
- Add INSTALL_XENU to the install kernels
- introduce the xbd disk devices to sysinst.
This will add 3 kernels to the i386 release:
XEN0 for use as a Xen domain0 kernel
XENU for use on a non-privileged domain
INSTALL_XENU to install NetBSD on a non-privileged domain virtual disk.
* Only futz with the done list in the soft interrupt handler. In the hard
interrupt handler, do nothing except mask WDH and queue the soft interrupt.
This simplifies a bunch of code, removes two O(n^2) queue manipulations,
and gets rid of some really sketchy stuff around the queue head access.
* Use the auto-masking code at the end of the interrupt handler for both WDH
and RHSC interrupts. Again, this reduces the code a little, and avoids
multiple writebacks to the chip registers.
* Improve some comments and (error) messages.
* Use EXIT_FAILURE and EXIT_SUCCESS.
* Add function `maybe_syslog' (only log when -l is enabled).
Reviewed by christos.
in connected state. Avoid a panic when the interface is configured
before being in connected state (e.g. when configured automatically by xend
when a domain is created).
