- Determine and remember if we are a floppy.
- Workaround for what is apparently a firmware bug - ignore the sector
size returned by the device. On my Firepower's floppy, block-size
is the same as max-transfer, which causes Lossage.
- Don't read the disklabel on a floppy; do what the ISA floppy driver
does, which is assign the entire disk to each "partition", although
we do not deal with the density stuff.
- FIREPOWERBUGS -> FIRMWORKSBUGS
- Some general cleanup.
by default if it's usable, but falling back to I/O space if mem isn't usable.
If NCR_IOMAPPED is defined (default on the x86), prefer I/O space
then fall back to mem. Also, clean up the various memory consistency checks
so that they can deal with run-time determination of whether or not the
device is to be memory- or I/O-mapped.
by default if it's usable, but falling back to I/O space if mem isn't usable.
If TULIP_IOMAPPED is defined (default on the x86), prefer I/O space
then fall back to mem.
mapping register, maps it, and returns all of the relevant information.
deprecate use of pci_{io,mem}_find(), but leave them around (for a while)
for backward compatibility with third-party drivers.
arguments, so that a device can tell if its memory and I/O spaces are
enabled. The flags are cleared, depending on the contents of devices CSR
registers, in the machine-independent PCI bus code.
this code makes equal sense for memory and I/O space, prefer to map
the PCI front end via memory space (conditionalized on a patchable kernel
variable), and do a bit of other random NetBSD-specific cleanup. (These
changes were sent to Justin Gibbs on March 28.)
This can be disabled (to save a bit of space) with the NO_KERNEL_RCSIDS
options, which is present but commented out in the ALPHA config file.
In ELF-format kernels, these strings are present in the kernel binary but
are not loaded into memory. (In ECOFF-format kernels, there's no easy way
to keep them from being loaded, so they _are_ loaded into memory.)
* Don't print DMA_OUT message in the `normal' case of a 16-byte residual.
* ioasic-connected 53c94 devices are always clocked at 25MHz even on
machines with 12.5MHz TurboChannel.
in reset. If none there, try and get from the bus/platform specific code.
If a nonzero value for either, set the clock rate. This is why the PCI
card versions weren't working- they need to be set at 60MHZ, rather than
the default 40MHZ (which worked fine for the internal ISP chips on the
Alpha 8X00).
B) If a isp_poll returns failure (command never completed) to the caller
and no error is set in the xs struct, set XS_SELTIMEOUT. And then call...
C) Added isp_lostcmd function to try and ask the ISP chip about it's current
state as well as the state of commands for a particular target/lun. This is
going along to try and figure out why the very first command to the ISP always
seems to get swallowed up.
byte comparisons. Compare the ethernet addresses backwards on the
assumption that address number byte 6 has the most random distribution,
so packets not for us spend the least time in here.
cgd