XXX I think we should have if_ne_pcmcia.c try to allocate I/O addresses
around 0x300 or we'll end up with a lot of quirks for NE2k based
cards which have bad CIS's.
be attached with this flag.
Some CF Card (for ex. IBM MicroDrive and SanDisk) doesn't seem to implement
drive select command. In this case, you can't eliminate ghost drive properly.
So you should use this flag to ignore the ghost by force.
This is the kernel part (userland to follow soon) of the latest (and
very probably last) release (version 0.96) of ISDN4BSD. ISDN4BSD has a
homepage at http://www.freebsd-support.de/i4b/.
It gives the user various ways to use the isdn connection: raw data (via
the i4brbch "raw b-channel" device), ppp (via the isp "isdn PPP" device),
voice/answering machine (the i4btel "telephone" device) and ip over isdn
(the ipr device, "IP over raw ISDN").
Supported are a bunch of common and older cards, more to be added soon
after some cleanup. Currently only the european E-DSS1 variant of the
ISDN D channel protocol is supported.
timeouts).
stop driver after suspend.
XXX: should use command interrupt but no document...
XXX: status update sometimes failed perhaps due to collision.
(RID 0xff50 or 0xff68 access failed)
No vendor ID, no product ID, and the wpp_cis_info is 'PCMCIA', 'CD-ROM'.
I'd be encouraged at some progress towards 'generic devices', except
someone else is bound to produce something that identifies the same, but
requires a quirk. Can I go back to my sparc now?
Make two other comments consistent while here.
Though ifconfig -m no longer show 5Mbps/11Mbps for PC4500 by this fix,
I cannot find how to set fixed transmit speed to the firmware.
FreeBSD version of driver apparently ignore the value set by ancontrol(8).
This is very adhoc work for IETF meeting.
- Since it seems that 'an' and 'wi' have similar hardware, low level
functions should be shared.
- There are PCI/ISA cards of Aironet but not supported yet.
- The wiconfig interface is changed so that wiconfig cannot be used.
- 'ancontrol' of FreeBSD is not ported.
- Only infrastructure mode is tested.
- WEP is not supported.
Though I only have an Aironet card, Cisco card should be expected to work.
- Doesn't fail ne_pcmcia_attach() if ne_pcmcia_ax88190_set_iobase() failed.
- Check whether LIOBASE register is writable or not (dirty hack!).
Fix PR. 11285
when sharing an interrupt with other devices:
check sc->sc_enabled, and drop the interrupt if its' off.
Also check for IFF_RUNNING, on advice of Enami Tsugotomo.
