errors for narrow transfers after a reselect. FreeBSD sym driver has a comment
about this, but their workaround (disable SCSI gross error reports) doesn't
work for me. Instead dissallow disconnect if the target is not wide
(FreeBSD doens't allow disconnect until the target has been fully probed, which
is why they may not have noticed my problem).
transmit and receive descriptor rings is limited to 256 descriptors.
So, set the if_snd queue length to 256 to let the upper layers queue
lots of packets, and let the driver handle up to 32 of them at a time.
(We should probably make this change to most Ethernet drivers, since
it actually saves some resources.)
* Increase the number of Tx DMA segments from 8 to 16.
* Clean up the way we count "how many times did I get a packet with N
DMA segments".
* Add a missing htole32() in wm_tx_cksum().
* Don't set both RS and RPS in the last Tx descriptor of a packet; just
use RS.
* Add some more information to the watchdog message.
so that they're more useful for arbitrary types of external storage:
* Add an "mbuf *" argument to (*ext_free)(). If non-NULL, (*ext_free)()
is expected to free the mbuf itself. This allows (*ext_free)() to use
the mbuf for bookkeeping (e.g. deferring the work to a helper thread).
If the "mbuf *" argument is NULL, we are assumed to be in a context
which is safe for performing the destructor operation *now*.
* Adjust MEXTREMOVE() and MFREE() routines for above change.
* Update "ade" and "ti" drivers for new semantics.
- Add support for DT transfers (aka Ultra/160) in esiop
Note that DT transfers are not enabled for 53c1010-33 rev 0 yet; if I trust
FreeBSD it has a bug which prevent them to do DT properly.
From the same source there may be issues with some revs of 53c1010-66.
taken from OpenBSD. Test hardware kindly provided by Intel. This still needs
management bits, and doesn't support older controllers, but that shouldn't
be hard to fix.
yet.
If is restricted to SIOP which implement the load/store instruction, and
has 10 scratch registers (basically, 825 and newer, possibly 770).
It implements a different interface between host and script, using a real
ring for command starts, and improved support for reconnect which will allow
256 tag per device. It uses interrupt on the fly to signal complete command,
which allows several commands to be serviced per interrupt and doesn't require
the script to stop to signal command completion.
So to disable them all better use 0xff instead of 0x00 as mask. Noted
by Matthias Drochner.
Move some initialization unrelated to interrupts back to its place at
attach time.
into a strange failure mode if we do it with disabled interrupt. When
(re-)enabling interrupts reset transmitter and receiver and clear any
pending state.
Note: The code is written a little more cruftily than it should be. It's also
only tested on the OSB4. I'm not sure it even makes sense to have support for
`native' mode, but I put it in just in case.
bouyer