Add lk_bell() to ring keyboard audible bell (for rcons bell).
Add LK_KEY_CLICK option to reset keyboard and enable keyclick.
(off by default since theres no way to control it from userland yet).
console setup and driver attach-time.
* Dont wire potential console lines as CLOCAL; use softcar.
* #ifdef tests on #ifdef NRASTERCONSOLE, not HAVE_RCONS.
* use dc_coldparam() in dc_tty_init(), dc_kbd_init().
* use dc_tty_init() to set line for serial console in dc_consinit()
* only call dc_mouse_init() if the console major-number is RCONSDEV.
- returned EOPNOTSUPP rather than -1.
- no check for negative offset.
many of these fix potential security problems in these drivers.
XXX XXX XXX
the d_mmap cdev routine should be changed to have a prototype like:
paddr_t (*d_mmap) __P((dev_t, off_t, int));
by someone!
Use scc_tty_init() in scc_consinit(). Declare scc_consinit() in sccvar.h.
* Remove last vestige of special-case console handling in sccparam() code.
* Call scc_consinit() from findcons scc_serial() console-setup.
Dont PROM for scc serial console at all.
attempt results in the up and down arrows not repeating in the X server.
The keyboard division table is modified to place the Right-Shift keycode
into division 6 along with the Left-Shift and Control. A corresponding
change to the X server lk201 keyboard handler is also required.
This got lost when disk geometry processing was updated.
Also move the CDROM check from rzread() to rzwrite() - it doesn't make
much sense to report a read-only filesystem error when trying to read a
CDROM.
struct scsipi_adapter; they were not used.
Add a scsipi_ioctl entry point to struct scsipi_adapter. This will be
used to issue ioctl commands to the host adapters.
Inspired by PR #6090, from Matt Jacob.
initialized yet. Use the base variable, and also use the symbolic symbols
to acdess the registers. Also, the console max_rows is based on the
display height, not the width.
controllers (including SCSI id 7 on the 2100/3100).
- On the pmax (2100,3100) set the host SCSI id to 6.
- Move disk and tape config for the second ASC controller from the GENERIC
config file to scsi.pmax so all configurations can use the second
controller.
* dec_5100.c: sysconf, interrupt, and motherboard (drain writebuffer)
support for 5100.
* support for hardware kludge in 5100: sii DMA buffer is hardware
padded to alternate 32-bit words, not alternating 16-bit halfwords.
* 5100 has no framebuffer, console is wired to serial port 0.
With ibus support, boots as far as exec'ing init, and hangs.
as pmax/dev/findcons.c:
* Follow the same logic: look for the device the PROM is using.
* If it's a framebuffer and we don't have a driver for it, try other
* framebuffers in PROM search order.
* If no match found, warn user and fall over to serial console.
* if no serial console found, go back to PROM.
Rework tc/scc.c attach routine to give cleaner initialization semantics.
Prune out old 'braindamage' code.
explorer