#if NBPFILTER is no longer required in the client. This change
doesn't yet add support for loading bpf as a module, since drivers
can register before bpf is attached. However, callers of bpf can
now be modularized.
Dynamically loadable bpf could probably be done fairly easily with
coordination from the stub driver and the real driver by registering
attachments in the stub before the real driver is loaded and doing
a handoff. ... and I'm not going to ponder the depths of unload
here.
Tested with i386/MONOLITHIC, modified MONOLITHIC without bpf and rump.
- Mostly sync with OpenBSD
- Serialise sending commands to the firmware
- Remove redundant calls to bpfdetach.
- use bus_size_t where appropriate and not fetch iobase as it's not
used.
- improve 802.11 radiotap support (correct rx rate)
- add short preamble flag
- add short slot time support
- ignore parity errors (as per the Linux driver)
- Set Tx power for all channels.
- disable bluetooth co-existance
- Check that ni->ni_rates.rs_nrates is not greater than the maximum
handled by the firmware.
- Begin syncing with the FreeBSD driver by renaming a few things.
boards. Currently, only the associated LED is being used because
that's the only LED my card has. The other two LEDs (OFDM and
activity) can later be set by someone, easily, who owns some board
with that LEDs.
Reviewed by Nick Hudson.
