isochronous reception routine for IEEE 1394 OHCI (fwohci). The
transmission part is under construction.
The minimum configuration options for this feature are:
# IEEE 1394 (i.LINK)
fwohci* at pci? dev ? function ?
pseudo-device fwiso 1
This situation is normal for asynchronous sources, and the byte stuffing
algorithm used generates unpleasant noise.
Also take care of scattered data buffer and do memcpy correctly.
This should fix PR kern/16385.
1. Clean up some debugging and trigger some on only extreme debugging needs
2. Comment alloc data mapping a bit better and fix some of the bugs here
(note..there still are some so for now the free method is never called while
I track these down)
3. Fix the copying logic in data_resp. It was calculating negative offsets
which blew up memcpy.
At this point I can probe, inquire and get through the findroot steps of a
boot:
sd0 at scsibus0 target 0 lun 0: <Maxtor, 1394 storage, 60> disk fixed
sd0: mode sense (4) returned nonsense; using fictitious geometry
sd0: 76293 MB, 76293 cyl, 64 head, 32 sec, 512 bytes/sect x 156250000 sectors
sd0: mode sense (4) returned nonsense; using fictitious geometry
sd0: no disk label
findroot: can't open dev sd0a (6)
NOTE: This will panic my machine right now with a simple disklabel -r sd0.
Also, since the free mappings routines are if (0)'d out at the moment do not
use this code for anything except experiments and then only on a machine
you don't mind panic'ing.
Fixing the mapping routines will be the next step and then finally chasing
down the proper mode sense these drives understand.
- Add support for byte system bus mode. Based on patch in kern/17193 by
Christian Groessler, with some improvements by me.
- Rename sc_flags in mb86960_softc to sc_stat, rename "type" to sc_flags
to specify controller quirks and remove enum mb86960_type.
- Pass controller type via new sc_flags in mb86960_softc rather than
via an mb86960_attach() arg.
- Handle unaligned mbufs properly in mb86960_write_mbufs(). (from ne2000.c)
- Fix a signed/unsigned comparision warning.
- Add definitions of status bits in the RX packed header.
- Change types of some members in mb86960_softc.
This change makes the driver work properly for the following card,
which used to function a bit weird:
eap0 at pci0 dev 10 function 0: Ensoniq CT5880 CT5880C (rev. 0x02)
eap0: interrupting at irq 9
eap0: TriTech TR28602 codec; no 3D stereo
