- most of the kernel code will not care about the actual encoding of
scope zone IDs and won't touch "s6_addr16[1]" directly.
- similarly, most of the kernel code will not care about link-local
scoped addresses as a special case.
- scope boundary check will be stricter. For example, the current
*BSD code allows a packet with src=::1 and dst=(some global IPv6
address) to be sent outside of the node, if the application do:
s = socket(AF_INET6);
bind(s, "::1");
sendto(s, some_global_IPv6_addr);
This is clearly wrong, since ::1 is only meaningful within a single
node, but the current implementation of the *BSD kernel cannot
reject this attempt.
- and, while there, don't try to remove the ff02::/32 interface route
entry in in6_ifdetach() as it's already gone.
This also includes some level of support for the standard source
address selection algorithm defined in RFC3484, which will be
completed on in the future.
From the KAME project via JINMEI Tatuya.
Approved by core@.
could modify the struct mbuf and calling functions (udp_input() and
udp4_realinput()) would have used a garbled local copy of the pointer.
The fix is not perfect. udp4_espinudp() should use m_pulldown()...
pass it to in_pcbbind() so that can allocate a low numbered port
if setsockopt() has been used to set IP_PORTRANGE to IP_PORTRANGE_LOW.
While there, fail in_pcbconnect() if the in_pcbbind() fails - rather
than sending the request out from a port of zero.
This has been largely broken since the socket option was added in 1998.
- for ipv4, defer decision to ip layer as h/w checksum offloading does
so that it can check the actual interface the packet is going to.
- for ipv6, disable it.
(maybe will be revisited when it implements h/w checksum offloading.)
ok'ed by Jason Thorpe.
net.local.stream.pcblist
net.local.dgram.pcblist
net.inet.tcp.pcblist
net.inet.udp.pcblist
net.inet.raw.pcblist
net.inet6.tcp6.pcblist
net.inet6.udp6.pcblist
net.inet6.raw6.pcblist
which allow retrieval of the pcbs in use for those protocols. The
struct involved is 32/64 bit clean and incorporates parts of struct
inpcb, struct unpcb, a bit of struct tcpcb, and two socket addresses.
Connect over tcp on the loopback is broken:
4729 amq 0.000007 CALL connect(4,0x804f2a0,0x1c)
4729 amq 75.007420 RET connect -1 errno 60 Connection timed out
(this can never have worked)
now I can use a "bge" gigabit interface with hw checksumming
ttcp-t: 2147483648 bytes in 18.31 real seconds = 114527.11 KB/sec +++
woow!
Gone are the old kern_sysctl(), cpu_sysctl(), hw_sysctl(),
vfs_sysctl(), etc, routines, along with sysctl_int() et al. Now all
nodes are registered with the tree, and nodes can be added (or
removed) easily, and I/O to and from the tree is handled generically.
Since the nodes are registered with the tree, the mapping from name to
number (and back again) can now be discovered, instead of having to be
hard coded. Adding new nodes to the tree is likewise much simpler --
the new infrastructure handles almost all the work for simple types,
and just about anything else can be done with a small helper function.
All existing nodes are where they were before (numerically speaking),
so all existing consumers of sysctl information should notice no
difference.
PS - I'm sorry, but there's a distinct lack of documentation at the
moment. I'm working on sysctl(3/8/9) right now, and I promise to
watch out for buses.
close sockets on address changes, which was deemed to be a bad idea and was
summarily removed, so there is no point in wasting effort on maintaining it
any more.
configured with ``options FAST_IPSEC''. Kernels with KAME IPsec or
with no IPsec should work as before.
All calls to ip_output() now always pass an additional compulsory
argument: the inpcb associated with the packet being sent,
or 0 if no inpcb is available.
Fast-ipsec tested with ICMP or UDP over ESP. TCP doesn't work, yet.
be inserted into ktrace records. The general change has been to replace
"struct proc *" with "struct lwp *" in various function prototypes, pass
the lwp through and use l_proc to get the process pointer when needed.
Bump the kernel rev up to 1.6V
manner as the ifaddr hash table. By doing this, the mkludge code can go
away. At the same time, keep track of what pcbs are using what ifaddr and
when an address is deleted from an interface, notify/abort all sockets
that have that address as a source. Switch IGMP and multicasts to use pools
for allocation. Fix a number of potential problems in the igmp code where
allocation failures could cause a trap/panic.
Do a little mbuf rework while here. Change all uses of MGET*(*, M_WAIT, *)
to m_get*(M_WAIT, *). These are not performance critical and making them
call m_get saves considerable space. Add m_clget analogue of MCLGET and
make corresponding change for M_WAIT uses.
Modify netinet, gem, fxp, tulip, nfs to support MBUFTRACE.
Begin to change netstat to use sysctl.
