but it is specified by IEEE Std 1003.1, 2004 Edition (POSIX) and
the X/Open standards (Issue 6 and XNS 5.2).
* revert change removing gethostent() from gethostbyname(3) man page
* delete kruft from gethnamaddr.c leaving only gethostent() as a
wrapper around _gethtent().
* revert recent changes to <netdb.h>
+ restore gethostent() prototype
+ restore freehostent() prototype; handle similar to non-shipped
getipnodby*() prototypes
+ use correct XOPEN_SOURCE version (520 not 500) for freeaddrinfo()
prototype; interface specified by XNS5.2 not XNS5
Reviewd by <christos> and <drochner>.
(E++):
o The static configuration table now identifies by HPC offset.
o Added sq(4) entries for IP12, IP20, and IP24.
o Accomodated HPC revision forcing based on kernel config flags.
adapter) to work on IP24:
o Force HPC and GIO slot endianness.
o Allow slots one and two to be masters and configure for
realtime mode.
Also, while we're here move IP22 invariants into the IP22 case.
I suspect that IP20 will work as well since it exhibited the same
broken DMA that IP24 did before I flipped the master bit.
* Assert RESET before powering off a socket.
* Turn on the output enable bit earlier so the interface actually drives CEn
and RESET.
* Tighten up the power-on timing a bit.
* Mention the specific timing values named in the spec.
For pccbb, be careful to always power off before zeroing PWRCTL.
back after touching the PCI registers.
This shouldn't be necessary, but somehow the controller detects the need for
VPP2=12V and automatically applies it, and gives us a "bad Vcc" error if we
turn it off accidentally.
rather than taking the value from the bios.
Should allow the system to use a serial console that is also a 'bios serial
console' and isn't in the bios serial port table.
Probably fixes (with a few other changes) PR port-i386/9236
o Quickly mention the existence of revisions 1, 1.5 and 3.
o Document the forced revision flags.
o Note support for revision 1 and 1.5.
o Document the 28bit pointer limitation in revisions 1 and 1.5.
* Rather than using mnt_maxsymlinklen to indicate that a file systems returns
d_type fields(!), add a new internal flag, IMNT_DTYPE.
Add 3 new elements to ufsmount:
* um_maxsymlinklen, replaces mnt_maxsymlinklen (which never should have existed
in the first place).
* um_dirblksiz, which tracks the current directory block size, eliminating the
FS-specific checks littered throughout the code. This may be used later to
make the block size variable.
* um_maxfilesize, which is the maximum file size, possibly adjusted lower due
to implementation issues.
Sync some bug fixes from FFS into ext2fs, particularly:
* ffs_lookup.c 1.21, 1.28, 1.33, 1.48
* ffs_inode.c 1.43, 1.44, 1.45, 1.66, 1.67
* ffs_vnops.c 1.84, 1.85, 1.86
Clean up some crappy pointer frobnication.
Move info about cylinders to the 'ask for units' menu.
(translations need checking, done by cutting sentences)
Stop i386 always asking for units.
Use BIOS cylinders for MBR and disk cylinders for the disklabel.
(code intended to do this, but got it wrong...)
Mark some menus as 'sub menu' or MC_SUBMENU so that the screen underneath
is saved.
Add GENERIC.MPACPI to i386 menu.
