a char *, because that's what was really intended, and because
if the print function modifies the string, various things could become
unhappy (so the string should _not_ be modified).
figure out the correct IRQ for the ethernet on the AlphaStation 500.
That code is enabled via KN20AA_BOGUS_IRQ_FROB (but hopefully won't be
needed any time soon, and won't link w/o slight changes to other code).
Basically, when establishing an interrupt that we don't know what to
do with, prompt the user for what interrupt line to enable. If you
get stray interrupts when you try to use the device (but not before),
then you've got the right line.
found on the AlphaStation 600), and interrupts on interrupt line 13.
Thanks to Andrew Gallatin for booting a test kernel 32 times (trying
each interrupt line, looking for the right one) to find this.
mapping code. (instead of using a "slot" and multiplying by 4 and adding the
pin number later to get the IRQ, just use base IRQ value and add the pin
number.)
>Update for present reality (function names), clean up a bit (printfs,
>"panic: foo XXX"), and fix a couple of printf format specified bugs
>(which were normally #if 0'd out). Inspired by Multia/UDB support
>changes sent by Matt Thomas.
and:
>changes from Matt Thomas so that the Multia/UDB can attach its
>'com' interrupts, cleaned up some. Basically: if sharing type of
>new interrupt is different than what the hardware is currently set up
>for (e.g. requesting edge-triggered and the hardware is set up by
>the PROM for level triggered) and there are no interrupt handlers on
>that line already, warn about it and use the hardware type that the
>line was already set for (to avoid making the console blow up on
>reboot). If same circumstances but there is already a handler, panic
>as before.
common back-ends that live on multiple very-different busses (e.g. PCI and
TC), which need bus-specific DMA mapping support. As a nice side effect,
this will allow the especially nasty (vtophys(va) | 0x40000000) expressions
to go away in favor of less nasty bus-specific function calls.
from the current apecs_pci.c. This new version hopefully works for
the same sets of devices that that previous one did, and hopefully
will work for multi-function devices and for secondary PCI busses as
well. (looking at the code, there was no way the old one could have!)
cgd