passed to sysctl_createv() actually matches the declared type for
the item itself.
In the places where the caller specifies a function and a structure
address (typically the 'softc') an explicit (void *) cast is now needed.
Fixes bugs in sys/dev/acpi/asus_acpi.c sys/dev/bluetooth/bcsp.c
sys/kern/vfs_bio.c sys/miscfs/syncfs/sync_subr.c and setting
AcpiGbl_EnableAmlDebugObject.
(mostly passing the address of a uint64_t when typed as CTLTYPE_INT).
I've test built quite a few kernels, but there may be some unfixed MD
fallout. Most likely passing &char[] to char *.
Also add CTLFLAG_UNSIGNED for unsiged decimals - not set yet.
- better named one
- not suffering from buffer oveflow
- simpler
- handling different separators
- returning error codes for errors
Some ideas from one posted on tech-net by Jonathan A. Kollasch
#if NBPFILTER is no longer required in the client. This change
doesn't yet add support for loading bpf as a module, since drivers
can register before bpf is attached. However, callers of bpf can
now be modularized.
Dynamically loadable bpf could probably be done fairly easily with
coordination from the stub driver and the real driver by registering
attachments in the stub before the real driver is loaded and doing
a handoff. ... and I'm not going to ponder the depths of unload
here.
Tested with i386/MONOLITHIC, modified MONOLITHIC without bpf and rump.
read/write/accept, then the expectation is that the blocked thread will
exit and the close complete.
Since only one fd is affected, but many fd can refer to the same file,
the close code can only request the fs code unblock with ERESTART.
Fixed for pipes and sockets, ERESTART will only be generated after such
a close - so there should be no change for other programs.
Also rename fo_abort() to fo_restart() (this used to be fo_drain()).
Fixes PR/26567
do drain' in many places, whereas fo_drain() was called in order to force
blocking read()/write() etc calls to return to userspace so that a close()
call from a different thread can complete.
In the sockets code comment out the broken code in the inner function,
it was being called from compat code.
than one active reference to a file descriptor. It should dislodge threads
sleeping while holding a reference to the descriptor. Implemented only for
sockets but should be extended to pipes, fifos, etc.
Fixes the case of a multithreaded process doing something like the
following, which would have hung until the process got a signal.
thr0 accept(fd, ...)
thr1 close(fd)
When a link-layer address changes (e.g., ifconfig ex0 link
02🇩🇪ad:be:ef:02 active), send a gratuitous ARP and/or a Neighbor
Advertisement to update the network-/link-layer address bindings
on our LAN peers.
Refuse a change of ethernet address to the address 00:00:00:00:00:00
or to any multicast/broadcast address. (Thanks matt@.)
Reorder ifnet ioctl operations so that driver ioctls may inherit
the functions of their "class"---ether_ioctl(), fddi_ioctl(), et
cetera---and the class ioctls may inherit from the generic ioctl,
ifioctl_common(), but both driver- and class-ioctls may override
the generic behavior. Make network drivers share more code.
Distinguish a "factory" link-layer address from others for the
purposes of both protecting that address from deletion and computing
EUI64.
Return consistent, appropriate error codes from network drivers.
Improve readability. KNF.
*** Details ***
In if_attach(), always initialize the interface ioctl routine,
ifnet->if_ioctl, if the driver has not already initialized it.
Delete if_ioctl == NULL tests everywhere else, because it cannot
happen.
In the ioctl routines of network interfaces, inherit common ioctl
behaviors by calling either ifioctl_common() or whichever ioctl
routine is appropriate for the class of interface---e.g., ether_ioctl()
for ethernets.
Stop (ab)using SIOCSIFADDR and start to use SIOCINITIFADDR. In
the user->kernel interface, SIOCSIFADDR's argument was an ifreq,
but on the protocol->ifnet interface, SIOCSIFADDR's argument was
an ifaddr. That was confusing, and it would work against me as I
make it possible for a network interface to overload most ioctls.
On the protocol->ifnet interface, replace SIOCSIFADDR with
SIOCINITIFADDR. In ifioctl(), return EPERM if userland tries to
invoke SIOCINITIFADDR.
In ifioctl(), give the interface the first shot at handling most
interface ioctls, and give the protocol the second shot, instead
of the other way around. Finally, let compatibility code (COMPAT_OSOCK)
take a shot.
Pull device initialization out of switch statements under
SIOCINITIFADDR. For example, pull ..._init() out of any switch
statement that looks like this:
switch (...->sa_family) {
case ...:
..._init();
...
break;
...
default:
..._init();
...
break;
}
Rewrite many if-else clauses that handle all permutations of IFF_UP
and IFF_RUNNING to use a switch statement,
switch (x & (IFF_UP|IFF_RUNNING)) {
case 0:
...
break;
case IFF_RUNNING:
...
break;
case IFF_UP:
...
break;
case IFF_UP|IFF_RUNNING:
...
break;
}
unifdef lots of code containing #ifdef FreeBSD, #ifdef NetBSD, and
#ifdef SIOCSIFMTU, especially in fwip(4) and in ndis(4).
In ipw(4), remove an if_set_sadl() call that is out of place.
In nfe(4), reuse the jumbo MTU logic in ether_ioctl().
Let ethernets register a callback for setting h/w state such as
promiscuous mode and the multicast filter in accord with a change
in the if_flags: ether_set_ifflags_cb() registers a callback that
returns ENETRESET if the caller should reset the ethernet by calling
if_init(), 0 on success, != 0 on failure. Pull common code from
ex(4), gem(4), nfe(4), sip(4), tlp(4), vge(4) into ether_ioctl(),
and register if_flags callbacks for those drivers.
Return ENOTTY instead of EINVAL for inappropriate ioctls. In
zyd(4), use ENXIO instead of ENOTTY to indicate that the device is
not any longer attached.
Add to if_set_sadl() a boolean 'factory' argument that indicates
whether a link-layer address was assigned by the factory or some
other source. In a comment, recommend using the factory address
for generating an EUI64, and update in6_get_hw_ifid() to prefer a
factory address to any other link-layer address.
Add a routing message, RTM_LLINFO_UPD, that tells protocols to
update the binding of network-layer addresses to link-layer addresses.
Implement this message in IPv4 and IPv6 by sending a gratuitous
ARP or a neighbor advertisement, respectively. Generate RTM_LLINFO_UPD
messages on a change of an interface's link-layer address.
In ether_ioctl(), do not let SIOCALIFADDR set a link-layer address
that is broadcast/multicast or equal to 00:00:00:00:00:00.
Make ether_ioctl() call ifioctl_common() to handle ioctls that it
does not understand.
In gif(4), initialize if_softc and use it, instead of assuming that
the gif_softc and ifp overlap.
Let ifioctl_common() handle SIOCGIFADDR.
Sprinkle rtcache_invariants(), which checks on DIAGNOSTIC kernels
that certain invariants on a struct route are satisfied.
In agr(4), rewrite agr_ioctl_filter() to be a bit more explicit
about the ioctls that we do not allow on an agr(4) member interface.
bzero -> memset. Delete unnecessary casts to void *. Use
sockaddr_in_init() and sockaddr_in6_init(). Compare pointers with
NULL instead of "testing truth". Replace some instances of (type
*)0 with NULL. Change some K&R prototypes to ANSI C, and join
lines.
like it is a device_t.
In tap_clone_creator(), set cf_fstate to FSTATE_FOUND instead of
_NOTFOUND to avoid a panic in config_detach() on a DIAGNOSTIC
kernel. XXX I'm not sure that that is the right fix.
These changes should put a stop to the crash described in kern/38759.
proclist_mutex and proclist_lock into a single adaptive mutex (proc_lock).
Implications:
- Inspecting process state requires thread context, so signals can no longer
be sent from a hardware interrupt handler. Signal activity must be
deferred to a soft interrupt or kthread.
- As the proc state locking is simplified, it's now safe to take exit()
and wait() out from under kernel_lock.
- The system spends less time at IPL_SCHED, and there is less lock activity.
- Add a lot of missing selinit() and seldestroy() calls.
- Merge selwakeup() and selnotify() calls into a single selnotify().
- Add an additional 'events' argument to selnotify() call. It will
indicate which event (POLL_IN, POLL_OUT, etc) happen. If unknown,
zero may be used.
Note: please pass appropriate value of 'events' where possible.
Proposed on: <tech-kern>
Add if_set_sadl() that both sets the link-layer address length and
replaces the current link-layer address with a new one, and use it
throughout the tree.
and dom_sa_len members from struct domain. Pools of fixed-size
objects are too rigid for sockaddr_dls, whose size can vary over
a wide range.
Return sockaddr_dl to its "historical" size. Now that I'm using
malloc(9) instead of pool(9) to allocate sockaddr_dl, I can create
a sockaddr_dl of any size in the kernel, so expanding sockaddr_dl
is useless.
Avoid using sizeof(struct sockaddr_dl) in the kernel.
Introduce sockaddr_dl_alloc() for allocating & initializing an
arbitrary sockaddr_dl on the heap.
Add an argument, the sockaddr length, to sockaddr_alloc(),
sockaddr_copy(), and sockaddr_dl_setaddr().
Constify: LLADDR() -> CLLADDR().
Where the kernel overwrites LLADDR(), use sockaddr_dl_setaddr(),
instead. Used properly, sockaddr_dl_setaddr() will not overrun
the end of the sockaddr.
identify sockaddr_dl abuse that remains in the kernel, especially
the potential for overwriting memory past the end of a sockaddr_dl
with, e.g., memcpy(LLADDR(), ...).
Use sockaddr_dl_setaddr() in a few places.
compatibility with the older ioctls. This avoids stack smashing and
abuse of "struct sockaddr" when ioctls placed "struct sockaddr_foo's" that
were longer than "struct sockaddr".
XXX: Some of the emulations might be broken; I tried to add code for
them but I did not test them.
sense when chaning the MAC address of the virtual interface as pointed
out by Hans himself.
So, introduce ether_nonstatic_aton() and make etherip(4) and tap(4) use it.
- struct timeval time is gone
time.tv_sec -> time_second
- struct timeval mono_time is gone
mono_time.tv_sec -> time_uptime
- access to time via
{get,}{micro,nano,bin}time()
get* versions are fast but less precise
- support NTP nanokernel implementation (NTP API 4)
- further reading:
Timecounter Paper: http://phk.freebsd.dk/pubs/timecounter.pdf
NTP Nanokernel: http://www.eecis.udel.edu/~mills/ntp/html/kern.html
dsl