mandatory for IPv6 (so we can't just validate by using connected pcb - we need
to allow traffic from unconnected pcb to do pmtud).
- if the traffic is validated by xx_ctlinput, allow up to "hiwat" pmtud
route entries.
- if the traffic was not validated by xx_ctlinput, allow up to "lowat" pmtud
route entries (there's upper limit, so bad guys cannot blow up our routing
table).
sync with kame
XXX need to think again about default hiwat/lowat value.
XXX victim selection to help starvation case
TODO: udp6, and sendto consideration. as pmtud is mandatory for IPv6,
it is rather important for us to support those cases.
TODO: more testing
TODO: kame sync
entering rtentry's for hosts we're not actually communicating
with.
Do this by invoking the ctlinput for the protocol, which is
responsible for validating the ICMP message:
* TCP -- Lookup the connection based on the address/port
pairs in the ICMP message.
* AH/ESP -- Lookup the SA based on the SPI in the ICMP message.
If validation succeeds, ctlinput is responsible for calling
icmp_mtudisc(). icmp_mtudisc() then invokes callbacks registered
by protocols (such as TCP) which want to take some sort of special
action when a path's MTU changes. For TCP, this is where we now
refresh cached routes and re-enter slow-start.
As a side-effect, this fixes the problem where TCP would not be
notified when a path's MTU changed if AH/ESP were being used.
XXX Note, this is only a fix for the IPv4 case. For the IPv6
XXX case, we need to wait for the KAME folks.
Reviewed by sommerfeld@netbsd.org and itojun@netbsd.org.
- parse IPv6 header by using common function, ip6_{last,next}hdr.
- fix behaivior in multiple AH cases.
make strict boundary checks on mbuf chasing.
(sync with latest kame)
of IPv4 transport layer code work correctly (specifically, ICMPv4
will transmit wrong packet if we don't strip AH here)
this is just for m_pulldown case. normal installations are not affected.
pfil information, instead, struct protosw now contains a structure
which caontains list heads, etc. The per-protosw pfil struct is passed
to pfil_hook_get(), along with an in/out flag to get the head of the
relevant filter list. This has been done for only IPv4 and IPv6, at
present, with these patches only enabling filtering for IPPROTO_IP and
IPPROTO_IPV6, although it is possible to have tcp/udp, etc, dedicated
filters now also. The ipfilter code has been updated to only filter
IPv4 packets - next major release of ipfilter is required for ipv6.
- interop issues in ipcomp is fixed
- padding type (after ESP) is configurable
- key database memory management (need more fixes)
- policy specification is revisited
XXX m->m_pkthdr.rcvif is still overloaded - hope to fix it soon
itojun