already support under another name:
wi0 at pcmcia0 function 0: NETGEAR MA401RA Wireless PC, Card, ISL37300PEval-RevA
wi0: 802.11 address <whatever>
wi0: using RF:PRISM2.5 MAC:ISL3873B(PCMCIA)
wi0: Intersil Firmware: Primary (1.0.7), Station (1.3.6)
Seems that we assume that the dram blocks are sorted, and that the first/lowest address is also where the kernel is.
If the above is not true, then we're on a kinetic (probably should make a better way to indicate this) So search for all dram blocks < with starting addr lower than the first block and remove them.
Currently there's minimal performance gain (which is odd as the SDRAM is meant to be faster, I'm wondering if we need to prod some hidden registers to set timing information.
Note that I still get 16MB/s compared with 7MB/s on RiscStation and 93MB/s on my cats. I'm thinking that something else is seriously nasty on acorn32.
called after quota so we don't end up with fsck and raidframe parity rebuild
taking forever after a crash/reboot.
While we are here check for raid[0-9].conf & raid[1-9][0-9].conf not
raid[0-9].conf & raid[0-9][0-9].conf
- aging ang clear inactivity stations
- DTIM field in beacon/probe response.
- ignore IFF_PROMISC for hostap mode, since 802.11 has 3 address fields,
so that promisc mode is not required for AP function.
any time we remove all access to a given virtual page,
we must invalidate the (write-through) L1 dcache.
pmap_remove() still had it, but pmap_kremove(), pmap_clear_reference()
and pmap_page_protect(VM_PROT_NONE) didn't and needed it.
fixes PR 18040.
section of another exception. This is likely to happen if the kernel
stack is misaligned, has dropped off the bottom of the PCB, or has
otherwise gone into orbit.
In this case, switch to a safe stack, save as much of the machine
state as possible and dump it to the console.
accessing the kernel stack, since a TLB miss on the kernel stack
will result in r24 being trashed.
Also clear the ES_CRITICAL flag just before returning to the
previous context.
/dev/ttyS0 crashed the kernel. This is because sacom_filltx uses some
uninitialized static variables. Pulling the salues from softc instead
fixes the problem (this is what was done before the drver was moved
from /sys/arch/hpcarm to /sys/arch/arm, anyway).
wiz