- consider non-primary (2nd and beyond) IPv4 address as "local", and prevent
outgoing ARP.
- for routing entries generated by ARP, make sure to set rt->rt_ifa equal to
rt_key, to help IPv4 source address selection for traffic to myself.
PR 13311.
caveats/TODOs:
- interface routes ("connected routes" in cisco terminlogy) is tied with the
primary (1st) IPv4 address on the interface. should be fixed with updates
to rt_ifinit().
- source address selection for offlink locations. 1st address tend to be used
with the current code
(you can configure it right by setting rt->rt_ifa accordingly).
have sys/net/route.c:rtrequest1(), which takes rt_addrinfo * as the argument.
pass rt_addrinfo all the way down to rtrequest, and ifa->ifa_rtrequest.
3rd arg of ifa->ifa_rtrequest is now rt_addrinfo * instead of sockaddr *
(almost noone is using it anyways).
benefit: the follwoing command now works. previously we need two route(8)
invocations, "add" then "change".
# route add -inet6 default ::1 -ifp gif0
remove unsafe typecast in rtrequest(), from rtentry * to sockaddr *. it was
introduced by 4.3BSD-reno and never corrected.
XXX is eon_rtrequest() change correct regarding to 3rd arg?
eon_rtrequest() and rtrequest() were incorrect since 4.3BSD-reno,
so i do not have correct answer in the source code.
someone with more clue about netiso-over-ip, please help.
Current status:
Only OHCI chip is supported (fwohci).
ping (IPv4) works with Sony's implementation (SmartConnect) on Win98.
sometimes works but not stable.
Not implemented yet:
IRM (Isochronous Resource Manager) functionality.
Link layer fragmentation.
Topology map.
More to do:
clean ups
MCAP
charactor device part
dhcp
There is no entry in GENERIC config file yet.
Follow sys/dev/ieee1394/IMPLEMENTATION to enable if_fw.
lukem