* Remove the "expected function" value. This was just causing problems with
multifunction cards. Differentiating the functions is better done by
checking the function type (which we now do in ep and sm).
* Add support for matching CIS strings. This necessitated changing the calling
pattern a little too.
Use this enhanced version rather than driver-specific versions that do the
same thing.
Also, remove the last vestiges of PCMCIA_STR_*.
case (ne@pcmcia) where we were using these to create a subregion, it is better
handled by calling bus_space_subregion().
Now there is a 1:1 mapping between I/O spaces in the config table and windows
mapped in the function. Rework the multifunction mapping code to take
advantage of this by using both I/O base addresses if necessary.
timeouts).
stop driver after suspend.
XXX: should use command interrupt but no document...
XXX: status update sometimes failed perhaps due to collision.
(RID 0xff50 or 0xff68 access failed)
Though ifconfig -m no longer show 5Mbps/11Mbps for PC4500 by this fix,
I cannot find how to set fixed transmit speed to the firmware.
FreeBSD version of driver apparently ignore the value set by ancontrol(8).
This is very adhoc work for IETF meeting.
- Since it seems that 'an' and 'wi' have similar hardware, low level
functions should be shared.
- There are PCI/ISA cards of Aironet but not supported yet.
- The wiconfig interface is changed so that wiconfig cannot be used.
- 'ancontrol' of FreeBSD is not ported.
- Only infrastructure mode is tested.
- WEP is not supported.
Though I only have an Aironet card, Cisco card should be expected to work.
dyoung