- length was one off in names and secrets.
- add win 98 kludge but we keep it disabled for now.
- setup the authorization bit early so that we don't end up doing ppp
negotiations without authorization.
timeout connection that made it to phase NETWORK yet. (For drivers using
the internal timeout mechanism; isdnd, that does the timeout handling for
ISDN drivers, still needs to be fixed.)
Thanks to Wolfgang Solfrank for finding this.
a configurable maximum (default: 5).
Some ISPs shut down accounts (at least temporarily) after to many bad
retries. This hit me recently due to a stupid pilot error and the fast
retry rate.
containing the userland visible thinks (i.e. ioctl definitions).
Remove all (both) old ioctls, as they had a brain dead API and made keeping
binary compatibility more or less impossible.
Replace by several new ioctls. While there, remove any arbitrary limits
(resulting from the old, broken ioctls) and allow any length of names
and passwords.
it again when going from INITIAL to STARTING. This has been done for
passive or auto-conecting interfaces always, but not for permanent
ones.
This fixes session reestablishement for PPPoE interfaces without LINK1 set,
and probably also closes PR kern/11161.
Thanks to Jared D. McNeill and Ross Harvey for sugesting debug methology.
Collect both local and remote address and set them to the interface in
one step (the peer adress was not set at all before).
This causes the peer address now to show up on the interface and all
messages to the routing socket to be send with correct data. The latter
has been the last missing piece to complete PPPoE support.
the bit mask of open NCPs got out of sync.
Defer the (potential) closing of LCP after a NCP went down until after
the state machines got updated.
This fixes PR kern/11161.
In this mode, the PPP packets start with the protocol identifier and don't
have any explicit framing (which may be added by the lower level driver).
Make input/output statistics a little bit more correct by adding a hardware
driver adjustable framing length for each packet (instead of the constant
value "3" used before).
While there, bump authentication name length from 32 to 48 (I have a
connection where I need more than 32). XXX - this should not be artificialy
limited at all.
the link level name for the interface (ifp->if_sadl) is allocated
before ifp->if_addrlen is initialized, which could lead to allocating
too little space for the link level address.
Do this by splitting allocation of the link level name out of
if_attach() and into if_alloc_sadl(), which is normally called
by functions like ether_ifattach(). Network interfaces which
don't have a link-specific attach routine must call if_alloc_sadl()
themselves (example: gif).
Link level names are freed by if_free_sadl(), which can be called
from e.g. ether_ifdetach(). Drivers never need call if_free_sadl()
themselves as if_detach() will do it if it is not already done.
While here, add the ability to pass an AF_LINK address to
SIOCSIFADDR in ether_ioctl() (this is what caused me to notice
the problem that the above fixes).
Rumors say there are archs without ISA busses, so avoid including
(uneccesarily) isa bus headers in MI files.
XXX this is the minimal solution, layer interface calls will have
XXX to be revisited later
