- use board address space > 4 MB, instead of iszthreepa(), to detect Z3-mode
boards. We dont want the bus, but want the address configuration.
- s/CV64CONSOLE/CV3DCONSOLE/
- s/cv3d_zorroIII == 1/cv3d_zorroIII/ and s/cv3d_zorroIII != 1/!cv3d_zorroIII/
* Add code to query CDs for size, from MI scsi cd.c. Use it on CDs.
* Set C partition size for CDs. 4.4bsd/pmax code only set `a' partition
size and required users to mount `a' partition, breking raw-device
access like "disklabel rz?".
* Avoid possible divide-by-zero call to howmany() from rzstart(),
on removable media that aren't ready at device-open time.
Verified to work on rrz42.
until a proper fix is available:
Perpetuate the 4.4bsd design even further. Change keyboard-driver
open routines to check for an active raster console. If active, set the
keyboard struct tty's t_winsize from the rcons t_winsize on first open.
See pr 4438 for remaining problems and discussion of a complete fix.
* add includes for sys/dev/scsipi headers.
* cut-and-paste mode_sense and disk-geometry sense code from sd.c,
with name changes sd -> rz.
* Write `rz_command()' to send SCSI sense commands based on
existing rz size-sensing code.
* get geometry info with page 4 and page 5 mode sense.
* use resulting geom info for default label, fake label, and when
using ultrix labels. (ultrix labels have no geometry info).
Fixes incrrect-label bugs with using sysinst to install onto
Ultrix-labelled disks.
to remove. The address of the pointer rather than the address of what
is pointed to was use to track the previous handler resulting in problems
when releasing a chained irq. (from John Ballance)
Added check for zero terminator after removing spaces in
get_bootconf_option(). This fixes a problem of matching NULL terminators
if there are trailing spaces in the boot args.
configured into the kernel, or when the platform is not supported.
Use the defopt'ed options, rather than NDEC_... and remove the needs-flag
hack that's existed for a while.
- clean up debug code
- Don't check ATAPI signature when probing ATA drives, ATAPI devices were
detected before
- Reset controller after disks probes. The probe, with some combinations of
ATA/ATAPI device keep it in a mostly working, but strange state (with busy
led on)
- The WDCF_IRQ_WAIT flag is now cleared by wdc_ata_intr and wdc_atapi_intr
when appropriate (helps recover from failure conditions)
- In wdcunwedge, send ATAPI_SOFT_RESET to non-ata drives
(helps recover from failure conditions)
- in wdctimeout be a bit more verbose when we missed an interrupt
- Always Increment xfer->c_skip where it should be
- Set the ITSDONE flag when a polled command completed.
for 12-bit addresses. This causes PCMCIA cards mapped at 0x400 and higher
to not function properly. However, the range 0x300-0x3ff causes some
laptops (e.g. the NEC Versa 6030X) to hang if cards are mapped there.
So, after some experimentation, we compromise. If the probe discovers
a 12-bit address bus, don't trust it. Instead, use the range 0x330-0x3ff.
This has been shown to work on the laptops that the 0x300-0x3ff range is
known to fail on.
is