removing assumptions that there are only two B channels and by
adding support for a varying number of channels.
Due to this, rename previously used isdn identified "bri" to "isdnif",
which better describes the current situation.
into a strange failure mode if we do it with disabled interrupt. When
(re-)enabling interrupts reset transmitter and receiver and clear any
pending state.
and move them in their proper places.
Move the BRI registry from layer 2 (duh!) to layer 4, so active cards
(which don't have layer 3 or layer 2 in their driver). Remove all remaining
hard coded controller and driver types. Remove any arbitrary hard coded
limits, at least those that show up in the internal API.
This fixes PR 15950.
configuration of devices logically attached to the ISA bus:
* Change the isa_attach_args to have arrays of io, mem, irq, drq
resources.
* Add a "pnpnames" and a linked list of "pnpcompatnames" to the
isa_attach_args. If either of these members are non-NULL,
direct configuration of the bus is being performed. Add an
ISA_DIRECT_CONFIG() macro to test for this.
* Drivers are not allowed to modify the isa_attach_args unless
direct configuration is not being performed and the probe fucntion
is returning success.
* Adapt device drivers -- currently, all driver probe routines return
"no match" if ISA_DIRECT_CONFIG() evaluates to true.
This now provides slightly more functionality than the FreeBSD layer1-newbus
interface. It was meant to be a simple change to one header and a few
c files, but the change rippled all through various stuff.
To prevent a change to the kernel<->userland interface right now the kernel
is now lying about card types to userland (but who cares). This will be fixed
when the userland interface changes, after layer 3 <-> layer 4 has been
fixed.
Functional changes:
Provide a clean interface for hardware drivers to attach to the upper
layers. This will need another small change in the B-channel handling
when a similar change to the layer 3 <-> layer 4 interface happens.
Avoid passing indices into global arrays of pointers around, instead pass
the pointers itself. Don't code hardware driver types by predefined magic
numbers (think LKM). Prepare for detachable drivers (think pcmcia).
While there remove some sets of function pointers always pointing to the
same function (meant to be the configurable set of D channel protocol
handlers). It is unlikely another supported D-channel protocol will fit into
that (maximal layer interface) abstraction. When we get support for another
protocol, we will need to come up with a workable interface. Besides, the
old implementation was, uhm, strange.
remove all (legacy) "i4b_" prefixes outside of sys/netisdn.
Prefix all card specific driver support files with the basename
of the driver bus attachement file.
Renamed here:
i4b_isic_isa.c -> isic_isa.c
i4b_avm_a1.c -> isic_isa_avm_a1.c
i4b_daic_isa.c -> daic_isa.c
i4b_itk_ix1.c -> isic_isa_itk_ix1.c
i4b_tel_s08.c -> isic_isa_tel_s08.c
i4b_tel_s016.c -> isic_isa_tel_s016.c
i4b_tel_s0163.c -> isic_isa_tel_s0163.c
i4b_usr_sti.c -> isic_isa_usr_sti.c
