Be consistant in the way that MSIZE, MCLSHIFT, MCLBYTES and NMBCLUSTERS
are defined.
Remove old VM constants from cesfic port.
Bump MSIZE to 256 on mipsco (the only one that wasn't already 256).
and use appropriately
- create more helper macros:
. cdev__xyz_init(c,n), such as cdev__ocri_init() for
/* open, close, read, ioctl */, etc.
. cdev__xRy_init(c,n), where nullop is used instead of enodev to dummy out
method `R' and the comments now read /* xxx (read) yyy */ instead
. cdev__xyz_t_init(c,n,t) - as per cdev__xyz_init, but sets d_type = t
as well
- use seltrue instead of dev_noimpl(poll,*), as (IIRC) cdevsw.d_poll should
always DTRT WRT returning a valid result. (a few devices previously
incorrectly returned ENODEV)
- use dev_noimpl(stop,enodev) instead of dev_noimpl(stop,nullop) if tty
== 0, because it doesn't matter if dev_type_stop isn't implemented in that
case, and it allows the use of the cdev__xyz_init macros. certain ports
(sparc,sparc64,x68k) used the nullop method for dev_type_stop in a few
drivers, whereas everything else uses enodev
- ensure that the comments are accurate WRT the behaviour of a given entry
- for sizeof(void *) == 8 arch, this is mandatory. MHLEN is too small
already (less than 80) and there are chances for unwanted packet loss due
to m_pullup restriction.
- for other cases, the change should avoid allocating clusters in most cases
(even when you have IPv4 IPsec tunnel, or IPv6 with moderate amount of
extension header)
portmasters: if your arch chokes with the change (high memory usage or
whatever), please backout the change for your arch.
contains the values __SIMPLELOCK_LOCKED and __SIMPLELOCK_UNLOCKED, which
replace the old SIMPLELOCK_LOCKED and SIMPLELOCK_UNLOCKED. These files
are also required to supply inline functions __cpu_simple_lock(),
__cpu_simple_lock_try(), and __cpu_simple_unlock() if locking is to be
supported on that platform (i.e. if MULTIPROCESSOR is defined in the
_KERNEL case). Change these functions to take an int * (&alp->lock_data)
rather than the struct simplelock * itself.
These changes make it possible for userland to use the locking primitives
by including <machine/lock.h>.
Tree structure:
- sys/arch/sh3: sh3 generic code
As commented, in-chip device drivers are put into sys/arch/sh3/dev.
- sys/arch/evbsh3: sh3 evaluation boards (pure sh3 CPU, no fancy external HW)
- sys/arch/mmeye: Brains mmEye, www.brains.co.jp
MI source code includes couple of #ifdef for sh3-coff support.
(sh3 uses coff or elf)
Needs some more improvements, especialy in sys/arch/sh3/conf/files.sh3,
to compile the tree (due to last minute tree structure change).
