Any problems reported by testers have been fixed, and massive
cross-compiling of kernels has shown that any problems that remain
with actually building kernels are not related to this.
not support a value (e.g., it's to be used as "options FOO" instead of
"options FOO=xxx"). options that take a value were converted to
defparam recently.
- minor whitespace & formatting cleanups
as config(8) will warn for value-less defparam options
- minor whitespace/formatting cleanup
- consolidate opt_tcp_recvspace.h and opt_tcp_sendspace.h into opt_tcp_space.h
the etc Makefile override that by putting USETOOLS into $.MAKEOVERRIDES
This way the default for kernel compiles is still to use the installed
toolchain instead of depending on $TOOLDIR. $TOOLDIR can be used by
simply adding USETOOLS=yes to the command line as usual.
Adjust each ports template to set the default no setting and also pull in
bsd.own.mk if they weren't already to ensure they'll build correctly
with the new toolchain setup.
This will allow improvements to the pmaps so that they can more easily defer expensive operations, eg tlb/cache flush, til the last possible moment.
Currently this is a no-op on most platforms, so they should see no difference.
Reviewed by Jason.
and with the comment '4.2BSD TCP/IP bug compat. Not recommended'
Add commented out 'TCP_DEBUG # Record last TCP_NDEBUG packets with SO_DEBUG'
(All hail amiga and atari which make some attempt to automate the
multiplicity of config files...)
each vm_page structure. Add a VM_MDPAGE_INIT() macro to init this
data when pages are initialized by UVM. These macros are mandatory,
but ports may #define them to nothing if they are not needed/used.
This deprecates struct pmap_physseg. As a transitional measure,
allow a port to #define PMAP_PHYSSEG so that it can continue to
use it until its pmap is converted to use VM_MDPAGE_MEMBERS.
Use all this stuff to eliminate a lot of extra work in the Alpha
pmap module (it's smaller and faster now). Changes to other pmap
modules will follow.
- pmap_enter()
- pmap_remove()
- pmap_protect()
- pmap_kenter_pa()
- pmap_kremove()
as described in pmap(9).
These calls are relatively conservative. It may be possible to
optimize these a little more.
and use appropriately
- create more helper macros:
. cdev__xyz_init(c,n), such as cdev__ocri_init() for
/* open, close, read, ioctl */, etc.
. cdev__xRy_init(c,n), where nullop is used instead of enodev to dummy out
method `R' and the comments now read /* xxx (read) yyy */ instead
. cdev__xyz_t_init(c,n,t) - as per cdev__xyz_init, but sets d_type = t
as well
- use seltrue instead of dev_noimpl(poll,*), as (IIRC) cdevsw.d_poll should
always DTRT WRT returning a valid result. (a few devices previously
incorrectly returned ENODEV)
- use dev_noimpl(stop,enodev) instead of dev_noimpl(stop,nullop) if tty
== 0, because it doesn't matter if dev_type_stop isn't implemented in that
case, and it allows the use of the cdev__xyz_init macros. certain ports
(sparc,sparc64,x68k) used the nullop method for dev_type_stop in a few
drivers, whereas everything else uses enodev
- ensure that the comments are accurate WRT the behaviour of a given entry
wiz