d679590033
Split the pre-computed ifnet checksum flags into Tx and Rx directions.
...
Add capabilities bits that indicate an interface can only perform
in-bound TCPv4 or UDPv4 checksums. There is at least one Gig-E chip
for which this is true (Level One LXT-1001), and this is also the
case for the Intel i82559 10/100 Ethernet chips.
2001-09-17 17:26:59 +00:00
456dff6cb8
Spell 'occurred' with two 'r's.
2001-09-16 16:34:23 +00:00
33d596bef8
Add support for incoming IP broadcast packets. The protocol for this is
...
worked out by observing RISC iX's behaviour, so it may be technically
wrong. The only implementations of IP-over-Econet for which I've got
sources don't support broadcasts.
Tested using broadcast ping from RISC iX to NetBSD, and using rwhod.
2001-09-16 15:08:39 +00:00
0f810d8948
eco_input():
...
Use m_copydata() to preserve the Econet header, so we don't depend on
notionally-unused areas of an mbuf remaining untouched.
Check that ARP-over-Econet requests are exactly eight bytes long.
Use m_pullup() before trusting mtod().
Between them, these make reception of unicast ARP responses work properly.
2001-09-16 12:16:50 +00:00
56536d5190
econet_inputframe: Check the header of each frame, and its length, to ensure
...
it looks like what we expect. This should help detect frames garbled by the
interface driver.
2001-09-15 23:03:11 +00:00
91dae8ca83
Add minimal IP-over-Econet support and a load of bug-fixes. I can ping,
...
unreliably, between my RISC iX and NetBSD boxes with this. There's a lot
of work to go before it's solid, though.
2001-09-15 17:27:24 +00:00
2aa509fcfb
Remember to call eco_input() for incoming broadcasts.
2001-09-13 19:19:21 +00:00
3f063023fa
Add routing boilerplate to eco_output, verbatim from ether_output.
...
Update copyright notice to include UCB in consequence.
2001-09-13 18:01:34 +00:00
a939e73e00
Add definition of mask/shift for seqence/fragment in sequence control field.
2001-09-11 12:25:18 +00:00
52b3d56b11
Add MI Econet support. This is lacking any interfaces to higher-layer
...
protocols, and lacking any timeouts, but it basically works, doing four-way
handshakes in both directions and incoming Machine Peek operations.
Oh, and Econet is Acorn's ancient, proprietary 500kbit/s networking
technology.
2001-09-10 23:11:05 +00:00
308d03266a
Make this interface cloning.
2001-09-04 20:41:32 +00:00
d400c78e55
Update location of IANA smi-numbers file, since the old one doesn't work any
...
more.
While I'm here, add IANA assignments 0xbe--0xc5.
2001-08-23 14:52:21 +00:00
2697773fb1
IFQ_PURGE cannot be used against ifqueue. use IF_PURGE.
2001-08-23 00:56:03 +00:00
e556ec903d
fix ALTQ support. less diff with kame. kjc@csl.sony.co.jp.
2001-08-20 02:18:58 +00:00
317073f06f
Install if_bridgevar.h.
2001-08-17 23:16:14 +00:00
9b50223a16
Only report expire time for DYNAMIC forwarding table entries.
2001-08-17 22:10:20 +00:00
460da35f85
Add support for building Ethernet bridges, based on Jason Wright's
...
bridge driver from OpenBSD, although the bridge code has been *heavily*
modified by me (the 802.1D code remains mostly unchanged from the
original).
2001-08-17 21:37:27 +00:00
74ad87bc53
gif interface now uses generic software interrupt
...
(on archs that support it). also, make gif ALTQ-capable on outgoing.
sync with kame, comments from thorpej.
2001-08-16 17:45:25 +00:00
74954dadf9
use unsigned variable types as appropriate
2001-08-05 18:07:51 +00:00
43383b1e36
simplify previous fix (0-length mbuf in mbuf chain). from freebsd
2001-08-03 21:11:57 +00:00
47133068ba
do not break from loop even if m_len == 0. it's valid to have
...
mbuf with m_len == 0 in mbuf chain.
2001-08-02 13:37:51 +00:00
ce781443e0
pass replay sequence number on sadb_x_sa2 (it's outside of PF_KEY standard
...
anyways).
2001-08-02 12:10:14 +00:00
32c36b5e14
fix logic to free up ifqueue on if_detach(). prev pointer was incorrectly set.
2001-08-02 01:42:38 +00:00
39bc63e6b3
raise IFF_UP on SIOCSIFADDR. commented by tv@netbsd, sync with kame
2001-07-30 11:12:58 +00:00
cad488d032
sync gif interface code with latest kame.
...
IFF_RUNNING is clearified. attach/detach logic is more clearner.
the old code mistakenly set IFF_UP by itself, now the behavior is gone.
2001-07-29 05:08:32 +00:00
c4a687384b
make sure to cleanup software interrupt queues (like ipintrq)
...
on interface detach, otherwise we will have a dangling pointer
from m->m_pkthdr.rcvif.
2001-07-29 03:28:30 +00:00
888b31fb38
indent fix
2001-07-28 01:13:56 +00:00
dc1d7df811
do not initialize rmx_mtu on RTM_ADD.
...
on gateway change, copy rmx_mtu from gateway only under the following condition:
- current MTU is not locked
- current MTU was discovered via PMTUD
XXX if gateway has MTU == 0, current MTU is set to 0 and we are going to
rediscover PMTU again. is it good or bad?
2001-07-26 05:47:37 +00:00
efe956a93f
do not copy rmx_mtu on RTM_ADD/RESOLVE. the fragment was mistakenly
...
introduced on 1.25, from other *bsd via kame. from thorpej
2001-07-25 07:13:44 +00:00
a20e50f72a
Duh, braino in last -- only kick the interface if we actually set
...
the MTU.
2001-07-25 03:18:46 +00:00
c7edeb2b4f
If we change the MTU, kick the interface; it may have to reprogram
...
registers for the new MTU.
2001-07-25 03:05:33 +00:00
cf7ae5ac15
clear ifindex2ifnet[] on if_detach.
2001-07-24 16:35:29 +00:00
bfac03b510
Update the max_linkhdr when we attach a fddi interface.
2001-07-24 06:29:13 +00:00
2990097219
repair validation on RTAX_GENMASK insertion. has been broken since 44bsd.
...
(freebsd3 has a fix since 1999, but has insufficient validation on sa_len)
2001-07-21 12:20:36 +00:00
866fc79bb9
validate sa_len on equal() macro. without the change we may touch the content
...
of a2 beyond a2->sa_len mistakelnly. sync with kame
2001-07-20 18:52:18 +00:00
661cd5d582
No need to clear part of struct rt_addrinfo in rt_xaddrs() since the only
...
caller clears whole the struct.
2001-07-19 00:12:09 +00:00
cbf41a143a
bzero -> memset
2001-07-18 16:43:09 +00:00
86774df023
Fix a slight bug introduced with revision 1.9 (IPv6 integration) where
...
the bit mask of open NCPs got out of sync.
Defer the (potential) closing of LCP after a NCP went down until after
the state machines got updated.
This fixes PR kern/11161.
2001-07-17 19:12:02 +00:00
accb35c3a2
Fix slight glitch from rev. 1.70: bp is not adjusted for next loop after
...
outputting some data.
Fix provided by isaki@par.odn.ne.jp in PR kern/13472.
2001-07-15 21:17:29 +00:00
fe1a05f50a
add ovbcopy macro for KAME compat.
2001-07-07 18:26:26 +00:00
5e920039c6
have ovbcopy() macro, for cross-BSD compatibility only.
2001-07-07 14:45:46 +00:00
4866f1a22b
Fix typo. s/extention/extension/
2001-07-05 08:38:24 +00:00
e2d6ca2037
Rename an IFM_1000_TX occurrence missed in previous.
2001-06-30 21:23:39 +00:00
8d829065a6
IFM_1000_TX -> IFM_1000_T, as (breifly) discussed on tech-net.
2001-06-30 17:53:58 +00:00
ab5a996fc5
When setting an address on an interface, for address families which
...
do not require changing the link-level address, only (*if_init)()
if the interface is not already RUNNING.
2001-06-29 18:12:09 +00:00
ed965d38ff
add more capability information and status from IEEE802.11b
2001-06-25 12:02:53 +00:00
74f0920eda
Take into account the two byte PPP protocol discrimator following the PPPoE
...
header when calculating the MTU. Ooops...
Thanks to Mario Kemper for noting this.
2001-06-24 20:35:50 +00:00
dd3d1120f0
Add definitions of the value for 'i_wepon' of ieee80211_nwkey to prepare
...
support for persistent keys.
2001-06-21 12:29:39 +00:00
91a63a0595
Protect interface queue manipulations by splnet(). Splsoftnet() is not
...
enough.
2001-06-18 12:32:47 +00:00
015f17a7cb
fix comment on ifi_lastchange, for 1.4 if_data
2001-06-14 06:37:34 +00:00
thorpej