multi-channel driver), or to SCSI_CHANNEL_ONLY_ONE if a
single-channel driver.
(2) use scsiprint() rather than a locally-defined autoconfig print
function, and kill any locally-defined print function.
a char *, because that's what was really intended, and because
if the print function modifies the string, various things could become
unhappy (so the string should _not_ be modified).
* Add an ACB_RESET flag, so that a BUS DEVICE RESET can be queued within the
driver.
* If ACB_ABORT or ACB_RESET is set during reselection, schedule a message and
assert ATN.
* Optimize aic_datain_pio(), aic_dataout_pio() and aicintr() somewhat.
* Schedule a timeout only when we select the target, so that commands can't
time out prematurely.
1) If we get an unexpected disconnect, issue a REQUEST SENSE, as recommended
by the SCSI-2 spec. If the target created a contingent allegiance condition,
this will clear it. Also, if it happened while sending a SDTR or WDTR message,
disable negotiation for that target.
2) Since some lame devices still don't deal correctly, make sure we deassert
ATN if our last message out is interrupted. If we get a MESSAGE PARITY ERROR,
we'll reassert ATN anyway. This should ensure that we never have to send a
MESSAGE NO OPERATION.
3) Set AIC_ABORTING only when actually sending a BUS DEVICE RESET or ABORT,
so we get better error detection.
4) Other internal reorganization of no consequence.
- split softc size and match/attach out from cfdriver into
a new struct cfattach.
- new "attach" directive for files.*. May specify the name of
the cfattach structure, so that devices may be easily attached
to parents with different autoconfiguration semantics.
* Make synchronous negotiation work.
* Use the bitbucket when the target requests too much data.
* Loop in aicintr() until we get to a state where we have to wait.
* Always enable disconnection.
* Add some more per-controller variables: initiator ID, clock frequency,
min and max sync period.
* Correct sync period calculations.
* Remove sc_progress.
* Move most of the reselection handling into a separate function.
* Remove some outdated comments.
* Remove message bytes from FIFO even when dropping them on the floor.
* Some cosmetic cleanup.
message outs should now work correctly (including retransmissions).
Multiple messages ins should be more efficient. Missing REQ after
reselection phase should now (correctly) cause a wait with ENREQINIT
set.
* Abstract out the reselection out sequence, and use it directly to
get sense info. (This is somewhat faster than the generic done/sched
sequence.)
* If there are no ACBs available, wait interruptibly for one.
* Leave the interrupt registers alone during message in/out; just
watch for phase change. Don't (incorrectly) reenable interrupts
during data in/out; defer that to aicintr().
* Handle command pointer per SCSI 2 spec.
* Other minor coding improvements.
thorpej