multi-channel driver), or to SCSI_CHANNEL_ONLY_ONE if a
single-channel driver.
(2) use scsiprint() rather than a locally-defined autoconfig print
function, and kill any locally-defined print function.
a char *, because that's what was really intended, and because
if the print function modifies the string, various things could become
unhappy (so the string should _not_ be modified).
profiling enabled. (named the same as what GENERIC kernel
would be named if configured with config -p, which would end up
generating the same kernel as this.)
figure out the correct IRQ for the ethernet on the AlphaStation 500.
That code is enabled via KN20AA_BOGUS_IRQ_FROB (but hopefully won't be
needed any time soon, and won't link w/o slight changes to other code).
Basically, when establishing an interrupt that we don't know what to
do with, prompt the user for what interrupt line to enable. If you
get stray interrupts when you try to use the device (but not before),
then you've got the right line.
found on the AlphaStation 600), and interrupts on interrupt line 13.
Thanks to Andrew Gallatin for booting a test kernel 32 times (trying
each interrupt line, looking for the right one) to find this.
* Make S expand to an absolute path at compile time.
* Use `-S' rather than `-x' to remove debugging symbols.
* Garbage collect unused variables.
* Reverse a handful of port-specific changes that do not correspond to
the common build model and are not needed.
a boot string for firmware that can do this, such as the SPARC and
the sun3 models. It is currently silently ignored on all other
hardware now, however. The MD function "boot()" has been changed to
also take a char *.
mapping code. (instead of using a "slot" and multiplying by 4 and adding the
pin number later to get the IRQ, just use base IRQ value and add the pin
number.)
start adding back in tracing printfs. add support for the virtual page
table. Now it gets to user-land code, but fails because i've not
added support to the context switch code to activate and deactivate pmaps.
cgd