- returned EOPNOTSUPP rather than -1.
- no check for negative offset.
many of these fix potential security problems in these drivers.
XXX XXX XXX
the d_mmap cdev routine should be changed to have a prototype like:
paddr_t (*d_mmap) __P((dev_t, off_t, int));
by someone!
struct scsipi_adapter; they were not used.
Add a scsipi_ioctl entry point to struct scsipi_adapter. This will be
used to issue ioctl commands to the host adapters.
Inspired by PR #6090, from Matt Jacob.
the hp300 port.
- Interrupts 3-6 use this immediately. Interrupt 7 is a special case,
and the VIA interrupts (1 and 2) will be addressed when that code is
rototilled.
- Modify the zs front end to register with the appropriate interrupt
controller: through the PSC on the AV Quadras, and direct to
interrupt 4 on the rest. Arrange to have the appropriate zsc_softc
supplied to us at interrupt time.
- Modify the direct ADB driver (and its PowerManager cousin) to call
intr_dispatch(), rather than zshard(). XXX This is a kludge, but at
least limits the brokenness to the ADB drivers, now.
As a side effect, this should fix PR 5590. Thanks to Bill Studenmund for
correctly determining the cause of the problem reported there.
resolves a great many issues, including Performa 58x interrupt handling
and offset displays on some models.
Programs that depend on the old (pre-NetBSD 1.1) grf interface may break.
That's actually a separate issue uncovered by this code, not caused by it.
serial echo work, but not sure. Tested by Paul Goyette.
A few of these changes can probably be backed out, but I'm not sure which.
This part should work for now, and get things going again. These fixes
should also get rid of the problem of things crashing just as zstty0 gets
configured.
handlers. (Only slot_ignore() and slot_noint() need this, and we already
have a place to put this information.) Adjust add_nubus_intr() so that if
the client_data arg is specified as NULL, pass the slot number as
client_data to the interrupt handler.
MACHINE_NEW_NONCONTIG interface implementation, which is now enabled
on all systems. Thanks to Jason Thorpe for his work on the hp300 port,
from which most of the code used here was derived.
XXX In spite of the fact that it works on the hp300, UVM does not (yet)
work well under load on mac68k.
