21143 and Quality Semiconductor QS6611 PHY.
QS6611 requires explicit reset on some hardware configuration. See
``Using the Intel 21143 with the Quality Semiconductor QS6611 Revision D4''
<http://www.intel.com/design/network/applnots/278239.htm> for details.
Models which should be supported by this change are
ZX345Q, ZX346Q, ZX348Q, (non-Q versions use different PHYs)
ZX414, ZX412, ZX444,
ZX442, ZX212, ZX214,
ZX374, ZX372, ZX244,
ZX424, ZX422.
Tested on ZX346Q.
Some information is from the ZNYX driver source code available from
the ZNYX web site <http://www.znyx.com/>.
multi-port cards (which need the shared-rom/intr stuff) and single-port cards
(which must not have it). previously we enabled sharing for all adaptec cards,
which caused problems if you had multiple single-port cards on the same PCI bus.
pci_attach_args *" instead of from four separate parameters which in
all cases were extracted from the same "struct pci_attach_args".
This both simplifies the driver api, and allows for alternate PCI
interrupt mapping schemes, such as one using the tables described in
the Intel Multiprocessor Spec which describe interrupt wirings for
devices behind pci-pci bridges based on the device's location rather
the bridge's location.
Tested on alpha and i386; welcome to 1.5Q
98715* series.
The MX98715AEC-[C,E] use a different location in the serial eerom for
LED control, and programming it with the original location's values
caused unpredictable behavior.
Also, start integrating fixes where media changes on an adapter
under load may fail. There's more work to be done here, but I need
to sort out our internal changes a little more carefully.
epic0 at pci0 dev 11 function 0 epic0: unable to wake up from ...
... print this:
epic0 at pci0 dev 11 function 0: unable to wake up from power state D3
cardbus_get_capability() [mirror change already made to if_tlp_pci.c]
- if_tlp_cardbus.c: If we don't find an ISV SROM, try to grab the
Ethernet address from the CIS.
- if_tlp_cardbus.c: set CardBus cards to store-and-forward mode from
the get-go.
- Put the TxThresh tables in tulipvar.h, and use them in the CardBus
and PCI front-ends to go to store-and-forward mode.
- Document the Xircom X3201-3 clone a little more.
pass 4.1 21143s, they have a 128-byte SROM, and thus use a different
SROM address size than all other pass 4.1 21143s.
A plea to hardware designers -- *please* read application notes for
the components you're using before putting your hardware together. Thanks.
