and exit.
Previously, combinations would produce unintended results, such as
deleting the primary IP on an interface, instead of deleting an specified
alias.
Currently, only Aironet ("an") driver/card can be used.
nwkey persist (IEEE 802.11 devices only) Enable WEP encryption for IEEE
802.11-based wireless network interfaces with the persis-
tent key written in the network card.
nwkey persist:key
(IEEE 802.11 devices only) Write the key to the persis-
tent memory of the network card, and enable WEP encryp-
tion for IEEE 802.11-based wireless network interfaces
with the key.
network interfaces. This works by pre-computing the pseudo-header
checksum and caching it, delaying the actual checksum to ip_output()
if the hardware cannot perform the sum for us. In-bound checksums
can either be fully-checked by hardware, or summed up for final
verification by software. This method was modeled after how this
is done in FreeBSD, although the code is significantly different in
most places.
We don't delay checksums for IPv6/TCP, but we do take advantage of the
cached pseudo-header checksum.
Note: hardware-assisted checksumming defaults to "off". It is
enabled with ifconfig(8). See the manual page for details.
Implement hardware-assisted checksumming on the DP83820 Gigabit Ethernet,
3c90xB/3c90xC 10/100 Ethernet, and Alteon Tigon/Tigon2 Gigabit Ethernet.
u_int8_t array to struct ieee80211_nwid to prepend length field.
The length field is necessary because IEEE 802.11 spec doesn't prohibit
even '\0' for SSID.
Though the name and the value of SIOC... macro is unchanged, this change
breaks binary compatibility. The only affected userland program on the
tree is ifconfig(8).
As Jason suggested on tech-net, it is better than live with problems
since there are no releases for this ioctls yet.
that gifconfig(8) would issue to configure tunnel endpoints. This
allows IP tunnel interfaces (`gif' right now, and `gre' later) to
be configured with ifconfig(8), and via /etc/ifconfig.<interface>.
Partially taken from similar changes in OpenBSD.
- Const poison the command functions a bit. We really need to clean
up the command function interface.
in_status() handles the whole inet address family. in_alias() handles
printout for single address (for both the primary address or an alias).
it is more consistent with, for example, the way at_status() is used.
matt