Use 38400 as the line speed, this is the default footbridge console speed,
changing it confuses a remote serial line. Also updated in dot.hdprofile
Change the BLOCKSIZE to 1k, and the default EDITOR to ed.
Add standin shell funcs for dmesg and grep.
Only run sysinst if it's actually in the image.
Most noticeable change is the addition of dhclient, we now prompt if the
user wants DHCP autoconfiguration.
Also added chio, rcmd, ping6, rtsol, scsictl
We now use the cut down versions of:
dhclient, ifconfig, ping, ping6 and route
The ramdisk has grown by about 200k, however the kernel can take that, we're
still a few 100k from the current 5MB limit for cats kernels.
- build (mdset/nm/strip) into ${filename} as one rule, and move ${filename}.gz
into separate rule
- rename MDSET.${filename}.nosymbols -> MDSET_NOSYMBOLS.${filename}
- rename MDSET.${filename}.post -> MDSET_POST.${filename}, and don't do
suffix handling here
- rework suffix handling:
- rename MDSET.${filename}.suffixes -> MDSET_SUFFIXES.${filename},
and change from list of suffixes to list of "suffix cmdtobuildsuffix",
where cmdtobuildsuffix is the name of the variable containing the
command to build ${filename}.${suffix} (available as "${.TARGET}").
- for each ${filename}.${suffix}, depend upon ${filename} and use
${cmdtobuildsuffix} to create the former.
- add separate ${filename}.${suffix}.gz rule
- mipsco & pmax: rename "install.gz" to "netbsd-INSTALL.gz", for
consistency and so the target to build the mdset kernel doesn't get
confused with general "install" target
- move guts of distrib/Makefile.inc to distrib/common/Makefile.distrib
(fixes problem caused by implicit include of ../Makefile.inc in certain
submake conditions triggered by makefiles not yet in tree)
- removed mkdir of ${RELEASEDIR}/*; rely upon "snap_pre" target of
etc/Makefile to create all the release directories
- renamed RELINSTALL to RELEASE_INSTALL
- renamed FLOPPYINSTDIR to FLOPPY_RELEASEDIR
- renamed MDSETDIR to MDSET_RELEASEDIR
- removed ITARGET
- move release target from top level to appropriate subdirectory
- ensure release target has correct depends
- replace miniroot's IMAGE_MD_POST with common/Makefile.image IMAGEPOSTBUILD
- Makefile.image: add realall: ${IMAGE}
MDEXTRA_SUFFIXES.${KERNEL} -> MDSET.${FILENAME}.suffixes
${KERNEL.${_K}}.post -> MDSET.${FILENAME}.post
This allows "default" rules for for MDSETTARGETS with FILENAMEs of "-"
by defined MDSET.-.post & MDSET.-.suffixes
- Document the above
- Use the above appropriately in various Makefiles
- Be a be quieter when building these kernels
- Add .WAIT syncs so that multiple kernels aren't built in parallel, because
the temporary filename is the same, and it also avoid hairy magic in
syncing the targets generated from MDSET.${FILENAME}.suffixes with
the master target for that ${FILENAME}
replace
TARGETS = KERNEL IMAGE [...]
with
MDTARGETS = KERNEL IMAGE FILENAME [...]
If FILENAME is "-", use "netbsd.${KERNEL}" as the target filename
The rest:
Update for new MDTARGETS syntax. In some cases, the kernel
name from the "old" method will be used to override the default.
This was tested using a custom INSTALL kernel. The current one is >4Mb
which the cats firmware can't currently boot. We need to decide what
needs to be removed from INSTALL.
matt