behavior changes:
- two iocts used by ndp(8) are now obsolete (backward compat provided).
use sysctl path instead.
- lo0 does not get ::1 automatically. it will get ::1 when lo0 comes up.
INCOMPLETE state, send the first solicitation in nd6_output(), regardless
of the timer value.
revised comments about rate-limiting accordingly.
sync w/kame
if the cache entry is for outgoing router.
perform on-linkness check before default router (re-)seletion.
do not play with interface direct route on nd6_rtrequest.
sync a lot of cosmetic changes. sync with kame
autoconfigured host. bug was that, we will lose default route on
"ifconfig gif0 destroy" even if default is not pointing to gif0.
reported by ume@mahoroba.org. sync with kame
now traffic on loopback interface will be presented to bpf as normal wire
format packet (without KAME scopeid in s6_addr16[1]).
fix KAME PR 250 (host mistakenly accepts packets to fe80::x%lo0).
sync with kame.
normal operation (/var can get filled up by flodding bogus packets).
sysctl net.inet6.icmp6.nd6_debug will turn on diagnostic messages.
(#define ND6_DEBUG will turn it on by default)
improve stats in ND6 code.
lots of synchronziation with kame (including comments and cometic ones).
have sys/net/route.c:rtrequest1(), which takes rt_addrinfo * as the argument.
pass rt_addrinfo all the way down to rtrequest, and ifa->ifa_rtrequest.
3rd arg of ifa->ifa_rtrequest is now rt_addrinfo * instead of sockaddr *
(almost noone is using it anyways).
benefit: the follwoing command now works. previously we need two route(8)
invocations, "add" then "change".
# route add -inet6 default ::1 -ifp gif0
remove unsafe typecast in rtrequest(), from rtentry * to sockaddr *. it was
introduced by 4.3BSD-reno and never corrected.
XXX is eon_rtrequest() change correct regarding to 3rd arg?
eon_rtrequest() and rtrequest() were incorrect since 4.3BSD-reno,
so i do not have correct answer in the source code.
someone with more clue about netiso-over-ip, please help.
Current status:
Only OHCI chip is supported (fwohci).
ping (IPv4) works with Sony's implementation (SmartConnect) on Win98.
sometimes works but not stable.
Not implemented yet:
IRM (Isochronous Resource Manager) functionality.
Link layer fragmentation.
Topology map.
More to do:
clean ups
MCAP
charactor device part
dhcp
There is no entry in GENERIC config file yet.
Follow sys/dev/ieee1394/IMPLEMENTATION to enable if_fw.
- add protection mechanism against ND cache corruption due to bad NUD hints.
- more stats
- icmp6 pps limitation. TOOD: should implement ppsratecheck(9).
with "beyondscope" icmp6 support).
"options FAKE_LOOPBACK_IF" will honor scope on loopback outputs. rcvif will
be real interface, not the loopback, just like when multicast loopback.
(sync with kame)
itojun