make bluetooth stack keep device_t instead of softc pointer as
device is not necessarily part of softc, and pass device_t to
driver callbacks. hci_devname is no longer required.
the Linux (BlueZ) API.
- L2CAP or RFCOMM connections can require the baseband radio link
mode be any of:
authenticated (devices are paired)
encrypted (implies authentication)
secured (encryption, plus generate new link key)
- for sockets, the mode is set using setsockopt(2) and the socket
connection will be aborted if the mode change fails.
- mode settings will be applied during connection establishment, and
for safety, we enter a wait state and will only proceed when the mode
settings are successfuly set.
- It is possible to change the mode on already open connections, but
not possible to guarantee that data already queued (from either end)
will not be delivered. (this is a feature, not a bug)
- bthidev(4) and rfcomm_sppd(1) support "auth", "encrypt" and
"secure" options
- btdevctl(8) by default enables "auth" for HIDs, and "encrypt" for
keyboards (which are required to support it)
hci_event.c:
- Convert memo->response.clock_offset to host-endian.
hci_ioctl.c:
- printf format tweak (size_t)
hci_link.c:
- Convert memo->response.clock_offset from host-endian.
- Tweak a DIAGNOSTIC message.
l2cap_signal.c:
- In l2cap_recv_config_req(), rp->scid is little-endian so make sure
we convert from host-endian.
from scw@
NetBSD Foundation Membership still pending.) This stack was written by
Iain under sponsorship from Itronix Inc.
The stack includes support for rfcomm networking (networking via your
bluetooth enabled cell phone), hid devices (keyboards/mice), and headsets.
Drivers for both PCMCIA and USB bluetooth controllers are included.
plunky