c7ba7e0c07
Try to make this test gracefully fail when npftest is not available
2012-09-18 08:28:15 +00:00
69d9b49983
Workaround infrastructure bug where additional rpath flags are added for
...
/lib, resulting in linker warnings for the compat case.
2012-09-13 21:13:34 +00:00
001611b06f
ATF wrapping of the npf tests
2012-09-12 14:06:31 +00:00
af67173111
Fix building with MKCOMPAT=no
2012-09-10 11:29:06 +00:00
b8a85c6989
Replace usleep(500000) with a synchronization over a pipe.
2012-09-04 22:31:58 +00:00
db95257927
Fix test timeout.
2012-09-03 21:27:14 +00:00
af44ca577f
There's a known-but-unresolved race condition in here somewhere that
...
causes these tests to sometimes deadlock. Since they run really fast
when they are successful, it doesn't do any good to wait for the
default 5-minute timeout. So explicitly set timeout for these tests
to just 30 seconds.
2012-08-31 04:02:21 +00:00
d52ebd2ff5
Close pipes on exit.
2012-08-16 20:16:06 +00:00
16465504ed
Wait for a child to initialise its network stack before sending a ping.
...
Decrease BIOCSRTIMEOUT to 500ms.
2012-08-16 19:42:23 +00:00
6d924f6074
Slightly reaarange, so that the 32bit version actually gets compiled
...
and linked with -m32.
2012-08-16 10:14:03 +00:00
324d0ec850
Do not disturb the atf output with debugging echos
2012-08-16 08:39:43 +00:00
196af63e15
Test contiguous buffer as well.
2012-08-15 21:36:00 +00:00
a5a1874fdf
Add __RCSID and and make a couple of stylistic changes.
2012-08-14 19:40:30 +00:00
e7e64dcaa1
Build and install t_bpfilter.
2012-08-14 19:13:54 +00:00
a385466d91
Add t_bpfilter test. At the moment, it only checks
...
that bpf program can read bytes from mbuf chain.
2012-08-14 19:09:15 +00:00
e3b23739ec
add fdpass tests
2012-08-13 11:15:05 +00:00
cb461c6808
Exclude tests that use rump
2012-08-08 13:57:05 +00:00
40114b997c
PR/46602: Move the rfc6056 port randomization to the IP layer.
2012-06-22 14:54:34 +00:00
543143cf18
Move more PR references from comments to ATF's "descr".
2012-03-18 09:46:50 +00:00
3b23191359
PR/44196 is now fixed, so don't expect a failure.
2012-01-13 16:28:44 +00:00
d1de422af2
Remove unused variable
2011-12-18 22:51:00 +00:00
48e7c88486
Add missing copyright ((c) @christos).
2011-11-05 19:01:42 +00:00
56b331c000
Move connect(2), listen(2) and socketpair(2) tests to the right place.
2011-11-05 18:19:01 +00:00
94a17dd165
socketpair test.
2011-11-04 02:23:39 +00:00
5d5cd00fc9
Fixed reversed/child parent and check the right variable for failure from
...
gson@
2011-10-04 16:28:26 +00:00
3608a76ca2
Fix the exceed test.
2011-10-03 14:55:23 +00:00
4bea49e915
use ATF_CHECK_MSG instead of err() in atf.
2011-09-30 19:12:35 +00:00
216c13827a
add back the raw test and fix typo in the libraries.
2011-09-28 23:11:12 +00:00
2a89e8adcf
revert part of previous that was wrong.
2011-09-28 22:19:52 +00:00
e244cf19e9
fix error message
2011-09-28 22:08:12 +00:00
9d31325887
Add a unix socket pathname size limit test.
2011-09-28 16:13:03 +00:00
b0aa149fb2
Add an rfc6056 test.
2011-09-24 18:34:18 +00:00
60e8629a5d
fix fallout from including signal.h from rump_syscallargs.h
2011-06-26 13:15:22 +00:00
5c85f3b56b
fix fallout from including signal.h in rump_syscallargs.h
2011-06-26 13:13:31 +00:00
9b4c1721f3
Instead of doing 'atf_check ... sh -c foo', just do 'atf_check ... -x foo'.
2011-05-14 17:42:28 +00:00
29b0298b15
Minor simplification
2011-04-26 18:42:08 +00:00
ed194e826a
Repeat the fragmentation on lo0 test, but with checksum on IFF_LOOPBACK
...
interfaces enabled.
2011-04-10 11:31:48 +00:00
3d772d583a
Remove expected failure, PR has been fixed.
2011-04-09 20:42:12 +00:00
c87fb89aa0
make netcfg produce sensible results in a non-atf env
2011-02-28 21:21:14 +00:00
233a38c913
Problem was fixed, don't expect to fail anymore
2011-02-10 07:47:50 +00:00
5e6b266d97
Time to start adding tests for the routing code to make that part
...
of the kernel more approachable.
Begin the task with an xfail test for PR kern/40455.
2011-02-08 10:11:28 +00:00
68e1e43ec7
add test for PR kern/44369
2011-01-11 10:51:45 +00:00
7e35902cb8
Use raw buffer size (not aligned value) to limit packet size
2011-01-05 14:43:40 +00:00
db69e273a2
Fix alignment of sndbuf (sparc64 got a SIGBUS in this test)
2011-01-05 14:08:12 +00:00
00a6054507
PR/44310: Alexander Nasonov: write to /dev/bpf truncates size_t to int
2011-01-03 02:53:15 +00:00
bc1c80f7e8
Substitute a surgical rump_server configuration for rump_allserver
...
now that it's possible. With warm fs cache, the startup time of
the former is 0.01s and the latter 0.1s. With cold caches it's
0.2s vs 2s.
2010-12-30 16:58:07 +00:00
5a30a389c0
atf-check => atf_check
2010-12-18 08:35:53 +00:00
91ed45ab3f
use ping -n, since technically we don't have dns
2010-12-14 19:08:22 +00:00
756d5b62e3
Add another version of the simple ping test, this time written as a
...
shell script and using rump_server, rump.ifconfig and rump.ping.
XXX: uses rump_allserver for now, though, since i noticed a problem
where the rump kernel syscall vector does not get updated for
dlopen()'d libraries (and hence if you dlopen librumpnet.so, socket()
still gives ENOSYS). Me be fixink it later.
2010-12-14 11:03:17 +00:00
1a21107ad9
Add an xfail test for the mbuf leak described in PR kern/44196.
...
This is yet another example of a simple test which would be much
trickier to execute against the host kernel. You would either need
to put networking in a complete lockdown, or do some "statistical"
methods where you trigger the bug many many times and attempt to
ascertain a rising trend in mbuf count. And, of course, the leaked
mbufs don't go away from the host kernel once the test ends. In
contrast, we *know* that there is no other networking activity in
a rump kernel, so we can execute the operation exactly once, plus
the leaked mbuf "disappears" when the test is done.
2010-12-06 11:32:01 +00:00
martin