The __UNCONST macro is now used only where necessary and the RW macros
are gone. Most of the changes here are consumers of the
sysctl_createv(9) interface that now takes a pair of const pointers
which used not to be.
Do a little mbuf rework while here. Change all uses of MGET*(*, M_WAIT, *)
to m_get*(M_WAIT, *). These are not performance critical and making them
call m_get saves considerable space. Add m_clget analogue of MCLGET and
make corresponding change for M_WAIT uses.
Modify netinet, gem, fxp, tulip, nfs to support MBUFTRACE.
Begin to change netstat to use sysctl.
- consider non-primary (2nd and beyond) IPv4 address as "local", and prevent
outgoing ARP.
- for routing entries generated by ARP, make sure to set rt->rt_ifa equal to
rt_key, to help IPv4 source address selection for traffic to myself.
PR 13311.
caveats/TODOs:
- interface routes ("connected routes" in cisco terminlogy) is tied with the
primary (1st) IPv4 address on the interface. should be fixed with updates
to rt_ifinit().
- source address selection for offlink locations. 1st address tend to be used
with the current code
(you can configure it right by setting rt->rt_ifa accordingly).
have sys/net/route.c:rtrequest1(), which takes rt_addrinfo * as the argument.
pass rt_addrinfo all the way down to rtrequest, and ifa->ifa_rtrequest.
3rd arg of ifa->ifa_rtrequest is now rt_addrinfo * instead of sockaddr *
(almost noone is using it anyways).
benefit: the follwoing command now works. previously we need two route(8)
invocations, "add" then "change".
# route add -inet6 default ::1 -ifp gif0
remove unsafe typecast in rtrequest(), from rtentry * to sockaddr *. it was
introduced by 4.3BSD-reno and never corrected.
XXX is eon_rtrequest() change correct regarding to 3rd arg?
eon_rtrequest() and rtrequest() were incorrect since 4.3BSD-reno,
so i do not have correct answer in the source code.
someone with more clue about netiso-over-ip, please help.
timeout()/untimeout() API:
- Clients supply callout handle storage, thus eliminating problems of
resource allocation.
- Insertion and removal of callouts is constant time, important as
this facility is used quite a lot in the kernel.
The old timeout()/untimeout() API has been removed from the kernel.
This is important, because for most protocols, link level fragmentation is
used, but with different default effective MTUs. (e.g.: IPv4 default MTU
is 1500 octets, IPv6 default MTU is 9072 octets).
after various m_adj()s have been done. Kludge around this with a cheesy
macro that knows where the drivers put the mac header in the first mbuf.
XXX There should be a better way to do this.
