back-end to indicate that the device always sees reads as 32-bit
transactions, even if the host does 8 or 16-bit reads.
This is necessary for the SH-5 "Cayman" on-board ethernet. The SMsC part
is behind an FPGA which maps all cpu reads to 32-bits transactions.
previously to note that they reference the RCS ID in "pcmciadevs".
Hence, committed versions which incorrectly pointed back to the RCS ID
of the "pcmciadevs" that existed prior to my addition. Corrected in this
commit.
already support under another name:
wi0 at pcmcia0 function 0: NETGEAR MA401RA Wireless PC, Card, ISL37300PEval-RevA
wi0: 802.11 address <whatever>
wi0: using RF:PRISM2.5 MAC:ISL3873B(PCMCIA)
wi0: Intersil Firmware: Primary (1.0.7), Station (1.3.6)
- aging ang clear inactivity stations
- DTIM field in beacon/probe response.
- ignore IFF_PROMISC for hostap mode, since 802.11 has 3 address fields,
so that promisc mode is not required for AP function.
written (i.e. is used uninitialised). The esiop SCRIPT may do this in some
circonstances (and it is safe) so bus_space_set_region_4() the RAM in
reset routine.
Problem reported and fix tested by Allen Briggs.
- Fix one typo (instead of two disable_rx, one disable_rx and one disable_tx)
[The other bug fix isn't appropriate since the was OACTIVE is dealt with
has been changed in NetBSD.]
quirk table.
* We want to hardwire BMSR_EXTSTAT, not BMSR_EXTCAP, when reading
the TBI BMSR.
* Fetch the GPIO bits from the GPIOR register after an auto-load,
rather than reading from the EEPROM directly.
Seeq 84220.
Also add an 84220-specific work-around for some braindamage (at least
in the PHY I'm working with) where the PHY always comes out of reset
isolated, regardless of the previous state of the BMCR_ISO bit. This
happens even if the PHY has address zero, which is contrary to the
part's datasheet...
The work-around is only applied if we notice BMCR_ISO is set when it
should be clear following reset. The fix is to wait 30mS and clear
it manually. (The change doesn't stick if it's cleared sooner than this)
on current-users, with cross-check and some improvement from linux-2.4.19
and FreeBSD-current.
Also don't set the APO_UDMA_CLK66 bit for Ultra/100 capable chipset, and
support Ultra/133 for the VT8233A.
