- remove gzopenfull() and gzdopenfull()
- un-bump minor number
- remove docs for gone functions.
traditionally this is an invalid change (removing an API from a library
without bumping the major.) it has been decided that this case is special
enough not to require that. no one should have been using these new
functions yet.
PS: this may cause "make install" to barf about older libraries already
being installed.
August 2003:
On NetBSD, when we get to ah_massage_headers(), ip->ip_len is in
network byte order and includes all bytes in the input packet.
Therefore we don't need to byte-swap it or to add `skip' back in,
before verifying the receive-side hash.
With this change, AH transport mode works against FreeBSD 4.9 fast-ipsec
(which also works against Win2k, &c., &c.).
log.
----------------------------
update copyright notice for 2004
----------------------------
add new statistics
Obtained from: madwifi
----------------------------
update radiotap support to reflect recent changes:
o move tx taps from ath_start to ath_tx_start so lots more
state is available to tap
o add tx flags
o add tx rate
o add tx power (constant for the moment)
o add tx antenna state
----------------------------
do proper subclassing of node free+copy; the previous hack falls apart when
the 802.11 layer does useful work
Obtained from: madwifi
----------------------------
transmit beacon frames directly instead of defering them to a swi; there
was too much delay
Obtained from: madwifi
----------------------------
update copyright notice for 2004
----------------------------
radiotap updates:
o force little-endian byte order for header
o pad header to 32-bit boundary to guard against applications that assume
packet data alignment
FreeBSD commit log:
----------------------------
use correct malloc type to allocate struct ieee80211_node's
Noticed by: phk
----------------------------
do proper subclassing of node free+copy; the previous hack falls apart when
the 802.11 layer does useful work
Obtained from: madwifi
----------------------------
transmit beacon frames directly instead of defering them to a swi; there
was too much delay
Obtained from: madwifi
----------------------------
update copyright notice for 2004
----------------------------
check more quickly (and directly) if an interrupt is pending; this reduces
work done in ath_intr when the irq is shared
Obtained from: madwifi
----------------------------
cleanup descriptor allocation if attach fails
Obtained from: madwifi
----------------------------
remove use IEEE80211_C_RCVMGT
----------------------------
radiotap updates:
o force little-endian byte order for header
o pad header to 32-bit boundary to guard against applications that assume
packet data alignment
----------------------------
Don't announce MAC addresses twice.
(ieee80211_ifattach() calls ether_ifattach().)
----------------------------
Make this compile on amd64.
"I'll cope" by: sam
----------------------------
When draining the tx queue reclaim any node references held in packets.
This fixes a problem when operating as an AP where clients would get
stuck in the node table because the reference count never went to zero.
----------------------------
When ath_hal_stoptxdma returns an error dma is still likely stopped
so don't just stop trying to send a beacon frame or we'll be more likely
to lose sync. This only seems to happen on some older chips.
----------------------------
use ath_reset instead of ath_init when recovering from a watchdog timeout:
resetting the hardware is sufficient, no need to reset the 802.11 fsm
----------------------------
make hw.ath.debug a tunable
----------------------------
make hw.ath.outdoor and hw.ath.countrycode tunables
----------------------------
split debugging messages up into classes;
ah_debug is now treated as a bit vector
----------------------------
update radiotap support to reflect recent changes:
o move tx taps from ath_start to ath_tx_start so lots more
state is available to tap
o add tx flags
o add tx rate
o add tx power (constant for the moment)
o add tx antenna state
----------------------------
o eliminate widespread on-stack mbuf use for bpf by introducing
a new bpf_mtap2 routine that does the right thing for an mbuf
and a variable-length chunk of data that should be prepended.
o while we're sweeping the drivers, use u_int32_t uniformly when
when prepending the address family (several places were assuming
sizeof(int) was 4)
o return M_ASSERTVALID to BPF_MTAP* now that all stack-allocated
mbufs have been eliminated; this may better be moved to the bpf
routines
FAST_IPSEC headers (with declarations of stats structures) in
userspace code. I haven't checked for strict POSIX conformance, but
Sam Leffler's FreeBS `ipsecstats' tool will now compile, if you
manually make and populate usr/include/sys/netipsec.
Committed as-is for Andrew Brown to check more of the sys/netipsec sysctls.
