optimization made last year. should solve PR 17867 and 10195.
IP_HDRINCL behavior of raw ip socket is kept unchanged. we may want to
provide IP_HDRINCL variant that does not swap endian.
- let ipfilter look at wire-format packet only (not the decapsulated ones),
so that VPN setting can work with NAT/ipfilter settings.
sync with kame.
TODO: use header history for stricter inbound validation
mandatory for IPv6 (so we can't just validate by using connected pcb - we need
to allow traffic from unconnected pcb to do pmtud).
- if the traffic is validated by xx_ctlinput, allow up to "hiwat" pmtud
route entries.
- if the traffic was not validated by xx_ctlinput, allow up to "lowat" pmtud
route entries (there's upper limit, so bad guys cannot blow up our routing
table).
sync with kame
XXX need to think again about default hiwat/lowat value.
XXX victim selection to help starvation case
TODO: udp6, and sendto consideration. as pmtud is mandatory for IPv6,
it is rather important for us to support those cases.
TODO: more testing
TODO: kame sync
entering rtentry's for hosts we're not actually communicating
with.
Do this by invoking the ctlinput for the protocol, which is
responsible for validating the ICMP message:
* TCP -- Lookup the connection based on the address/port
pairs in the ICMP message.
* AH/ESP -- Lookup the SA based on the SPI in the ICMP message.
If validation succeeds, ctlinput is responsible for calling
icmp_mtudisc(). icmp_mtudisc() then invokes callbacks registered
by protocols (such as TCP) which want to take some sort of special
action when a path's MTU changes. For TCP, this is where we now
refresh cached routes and re-enter slow-start.
As a side-effect, this fixes the problem where TCP would not be
notified when a path's MTU changed if AH/ESP were being used.
XXX Note, this is only a fix for the IPv4 case. For the IPv6
XXX case, we need to wait for the KAME folks.
Reviewed by sommerfeld@netbsd.org and itojun@netbsd.org.
cbc-over-mbuf functions in sys/crypto.
the change should make it much easier to switch crypto function to
machine-dependent ones (like assembly code under sys/arch/i386/crypto?).
also it should be much easier to import AES algorithms.
XXX: it looks that past blowfish-cbc code was buggy. i ran some test pattern,
and new blowfish-cbc code looks more correct. there's no interoperability
between the old code (before the commit) and the new code (after the commit).
XXX: need serious interop tests before move it into 1.5 branch
sync with kame.
loopback, blowfish-cbc transport mode, 128bit key
before: 86588496 bytes received in 00:42 (1.94 MB/s)
after: 86588496 bytes received in 00:31 (2.58 MB/s)
