written (i.e. is used uninitialised). The esiop SCRIPT may do this in some
circonstances (and it is safe) so bus_space_set_region_4() the RAM in
reset routine.
Problem reported and fix tested by Allen Briggs.
- Fix one typo (instead of two disable_rx, one disable_rx and one disable_tx)
[The other bug fix isn't appropriate since the was OACTIVE is dealt with
has been changed in NetBSD.]
quirk table.
* We want to hardwire BMSR_EXTSTAT, not BMSR_EXTCAP, when reading
the TBI BMSR.
* Fetch the GPIO bits from the GPIOR register after an auto-load,
rather than reading from the EEPROM directly.
Seeq 84220.
Also add an 84220-specific work-around for some braindamage (at least
in the PHY I'm working with) where the PHY always comes out of reset
isolated, regardless of the previous state of the BMCR_ISO bit. This
happens even if the PHY has address zero, which is contrary to the
part's datasheet...
The work-around is only applied if we notice BMCR_ISO is set when it
should be clear following reset. The fix is to wait 30mS and clear
it manually. (The change doesn't stick if it's cleared sooner than this)
on current-users, with cross-check and some improvement from linux-2.4.19
and FreeBSD-current.
Also don't set the APO_UDMA_CLK66 bit for Ultra/100 capable chipset, and
support Ultra/133 for the VT8233A.
mediaopt adhoc 802.11 adhoc (IBSS) mode. IBSS creation is enabled
for cards which can create IBSS.
mediaopt adhoc,flag0 old lucent adhoc demo mode.
Note that [adhoc] media options for wi driver was used for adhoc demo mode,
which is NOW CHANGED.
sync that descriptor with PREREAD to make sure that it is evicted
from the data cache. From Allen Briggs.
* With the above bug fixed, stop using BUS_DMA_COHERENT, resulting in
a fairly decent performance improvement on systems where BUS_DMA_COHERENT
causes descriptors to be accessed uncached (most painful in wm_start()).
load f/w images > 0x7fff words), set ISP_FW_ATTR_SCCLUN. We explicitly
don't believe we can find attributes if f/w is < 1.17.0, so we have to
set SCCLUN for the 1.15.37 f/w we're using manually- otherwise every
target will replicate itself across all 16 supported luns for non-SCCLUN
f/w.
- centralize pcmcia function allocation and free'ing.
- free the cfe too, not just the pf in the multifunction card case.
- don't free pointers while walking the list, because free() will
fill the memory with deadbeef, thus killing list walking.
EXCLUDE_UNENCRYPTED bit in the WI_RID_P2_ENCRYPTION value if we are
in shared key mode. Symbol cards, just to be different, supposedly
always want the EXCLUDE_UNENCRYPTED bit set (confirmed with the
Linux orinoco and spectrum24 drivers).
* Flesh out the Host-AP WEP transmit side. Note this does not yet
work properly; the frame as seen by the receiver FCS's incorrectly.
Both changes from OpenBSD. Not confirmed whether or not Host-AP WEP
works with OpenBSD (mail sent to millert).
-Free AGP memory on close, to avoid a memory leak in case
the X server doesn't free it explicitely.
(It appears that the X server never calls AGPIOC_DEALLOCATE.)
Fixes PR kern/17869 by Emmanuel Dreyfus.
WEP for APs is not yet implemented, but without WEP, this works well
enough for my laptop to associate with an AP running this code.
Adapted from OpenBSD.
in this info based on firmware type and version. Replace "wi_has_wep"
with a flag.
* For cards which support IBSS, add "ibss" has a media option.
* For cards which support CREATE_IBSS, add "ibss-master" as a media
option.
* Use the "ibss" and "ibss-master" media options to determine if
we should go into IBSS mode and/or create the IBSS.
* Internally convert between the generic WI_PORTTYPE_IBSS and the
value the firmware wants to use for IBSS.
* When setting the IBSS name, if a desired-SSID is set, and we're
an ibss-master, write the desired-SSID into the own-SSID slot.
This ensures that "ifconfig wi0 nwid FOO" will do the expected
thing.
* Only set the roaming mode if the card supports roaming.
From OpenBSD.
