1) Removing chio, rcmd, restore, scsictl, shutdown and slattach
from the ramdisk images
2) Removing the isp* driver from the INSTALL kernel configs
3) Reducing the memory disk and ramdisk size back from 4400 to 4200 blocks
As a result, also remove mention as QLogic ISP controllers as being
supported by the installation.
With this, the INSTALL kernel images should once again be usable;
the firmware apparently imposes a size limit around 5MB on the files
it will load.
Longer-term, this port probably ought to get it's own stand-alone boot
loader, so that it might use e.g. loadable modules.
Most noticeable change is the addition of dhclient, we now prompt if the
user wants DHCP autoconfiguration.
Also added chio, rcmd, ping6, rtsol, scsictl
We now use the cut down versions of:
dhclient, ifconfig, ping, ping6 and route
The ramdisk has grown by about 200k, however the kernel can take that, we're
still a few 100k from the current 5MB limit for cats kernels.
- move guts of distrib/Makefile.inc to distrib/common/Makefile.distrib
(fixes problem caused by implicit include of ../Makefile.inc in certain
submake conditions triggered by makefiles not yet in tree)
- removed mkdir of ${RELEASEDIR}/*; rely upon "snap_pre" target of
etc/Makefile to create all the release directories
- renamed RELINSTALL to RELEASE_INSTALL
- renamed FLOPPYINSTDIR to FLOPPY_RELEASEDIR
- renamed MDSETDIR to MDSET_RELEASEDIR
- removed ITARGET
- move release target from top level to appropriate subdirectory
- ensure release target has correct depends
- replace miniroot's IMAGE_MD_POST with common/Makefile.image IMAGEPOSTBUILD
- Makefile.image: add realall: ${IMAGE}
This was tested using a custom INSTALL kernel. The current one is >4Mb
which the cats firmware can't currently boot. We need to decide what
needs to be removed from INSTALL.
abs