with IEEE, so use the "real" OUIs for definitions.
Now unfortunately vendors differ in how the MII ID register bits are
used wrt bit and byte ordering. There is a straightforward way - bits
numbered from LSB to MSB - used by AMD, Intel, NS and QS. This is used
by the current MII_OUI() conversion macro. ICS, Seeq, SiS and TI count
the bits as they appear on the wire, and some differ completely.
Account for these cases by "xx" prefixed OUI definitions which compensate
for this, so the MII_OUI() macro can still be used.
Add AMD (the "real" AMD this time) and the 79c973 PCnet internal PHY.
interface border, so that other serial interfaces can be attached to the
ms/kbd. zero functional changes and mostly involves moving code around
a bit. tested on the SS2.
this is necessary to attach the PCI ultrasparc keyboard/mouse drivers.
the code to pick the first USB keyboard instance as the console, ignoring
which USB controller it's on. Should eventually allow detaching of the
console keyboard.
From Jason Thorpe <thorpej@nas.nasa.gov>
(e.g., the 1240). Include the new 1080/1240 NVRAM layout reading code. Some
moderately significant mailbox changes were necessary also to accomodate a
second channel.
has the console input device. The USB keyboard driver uses this to
attach the first USB keyboard instance as the console keyboard.
Unfortunately, this must still be deferred to autoconfiguration time,
but there's not much we can do about that right now.
By code inspection I found 2 bugs in the ATAPI code, one may be the cause
of your problem: A counter is not reset when issuing the request_sense
command. This is c_skip, the counter used to track the offset in the data
buffer when a data tranfer needs multiple phases. The effect of this is that
the sense data transfered may be stored outside the sense buffer (sense buffer
+ some, potentially several KB, offset). This can only occur in PIO mode,
DMA is not affected.
This doesn't occur in "normal" use because when reading a data CD, either
the sense is issued for a non-data command (in which case c_skip stays to
0), or an error occured and no data has been transfered, and c_skip is still 0.
I can't see a case where a data READ/WRITE could cause a sense tranfer without
error.
The second problem is that b_resid can be set to a false value (resulting of
the sense tranfer and not the data transfer). Again this is not a problem with
usual data tranfers because both values ends up being 0 when no error occurs.
ad