PCI_INTR_FIXUP code "work" again.
Most of the time it will produce a warning about a misaligned resource
pointer, but it's harmless, and the warning was removed in the next version
of the ACPI-CA code.
Trident Microsystems 4DWAVE DX (ethernet network, revision 0x25)
Unfortunately, this is an autri sound card. Special case the match routines
for both drivers so if_pcn properly picks it up, and autri doesn't.
registers after switching to a VESA linear framebuffer mode is not
guaranteed to work. This should fix the majority of the problems people
have been experiencing with vesafb.
XXX: Still doesn't fix the assertion in wscons with options DIAGNOSTIC.
so invalidate the WEP key registers to force us to write the keys
back to the hardware.
Revamp key handling: use the hardware WEP engine for 40-bit and
104-bit keys, only; use software WEP for all other key lengths.
Set the hardware key length to the length of the default Tx key,
or if there is no default Tx key, use the length of the longest
WEP key.
and ADT 7463c thermal and voltage monitor found on the Tyan S2881 and S2882-D
(and probably other boards as well). We do not currently support any kind
of detection of the i2c address of the thermal monitor; it appears to be
at 0x2D on the S2881 and 0x2E on the S2882-D (kernel config examples
forthcoming).
From PR kern/32463 submitted by Anil Gopinath, anil_public@yahoo.com.
as we enter the IEEE80211_S_AUTH and IEEE80211_S_ASSOC states, so
that we don't send 802.11 Authentication and Association frames
with BSSID=00:00:00:00:00:00.
of calling rt_ifmsg directly. This allows other parts of the kernel
to change the behaviour depending on the link state and is a
prerequirement for CARP.
Hide mii_phy_statusmsg, mii_phy_update should be used instead.
Don't send routing messages for baudrate changes, if_baudrate is
currently not exported via this interface.
OK tls@
* Add WSDISPLAY_TYPE_VESA for vesafb. While here, fix a typo in a comment.
* Add WSDISPLAYIO_SSPLASH and WSDISPLAYIO_SPROGRESS ioctls. The former
toggles the splash screen on and off, and the latter updates the progress
animation.
* Prevent more than one hw driver from claiming to be the console.
* In vcons, keep two pointers to the screen's vcons_data. This lets us
override the original (ie with null emulops during boot), and restore
them later on.
