hasn't been seen by anyone yet, why encourage its use by defining it?
2) Indicate in a comment that the NetBSD define is now frozen, will
never again be incremented, and may even be deprecated. Indicate
yet again that all new code must use __NetBSD_Version__
clean bit. This is somewhat bogus as RAID 0 does not have any parity,
but is a slightly cleaner than other solutions, and makes the handling
of clean bits for RAID 0 consistent with the handling of clean bits at
other RAID levels.
The problem is that if "sl" is a symbolic link, a lookup on "sl/"
will be flagged as the last component. Thus VOP_LOOKUP will lock
the parent directory if LOCKPARENT is set. In order for the symbolic
link to be resolved, this lock needs to be released. namei() would
test for this by checking if ni_pathlen == 1, which it wouldn't as
"/" is left in the name, and namei() would not unlock the parent.
The next call to lookup() to resolve the symbolic link would fail
as the parent was still locked.
initialized). This lock also protects the "next drain candidate" pointer.
XXX There is still one locking protocol problem, which should not be
a problem in practice, but is still marked as an issue in the code anyhow.
dereference it when doing handled or modified emulation. This can happen
if fault are taken during early parts of the bootstrap, resulting in
recursive faulting.
are all the same, so eliminate the redundancy. also, use mrg's
"Version:" trick to find the version rather than using the RCS ID.
(I must have been having a ... bad day.) Also, bump boot and netboot
versions for all the changes that have been happening lately.
a data structure after it was freed. This wasn't actually a problem,
and the change caused the wrong pool_item_header to be freed
in the non-PR_PHINPAGE case.
in the air to deal with it.
Basically, following a kernel fault (eg. dereferencing a NULL pointer
in kernel mode) a DDB 'trace' did not show the function where the
fault occurred. For example:
db> trace
_Debugger()
_panic()
_trap()
faultstkadj()
_pool_drain()
_uvm_pageout()
_start_pagedaemon()
_proc_trampoline()
db>
The 'faultstkadj()' line here is bogus. It is shown because the return
address to 'trap()' happens to point there, and since faultstkadj() has
no stack frame, DDB assumes it was the faulting function. In this example,
the _real_ function was pool_reclaim(), but you would have to look at
the program counter at the time of the fault to figure that one out.
This fix makes the trace command do the dirty work for you by grubbing
around in 'trap()'s argument list to find the *real* PC value at the
time of the fault, replacing the 'faultstkadj()' line with the real
function's name.
* The MNT_UPDATE case had a null pointer dereference. (This is a good example
of why blindly adding bogus initializiers is a FUNDAMENTALLY BAD IDEA!)
* Make sure the whole ufsmount is zeroed, as the export code relies on this.
* If we decided to use the second/alternate superblock, make sure to copy the
in-core version from the right buffer.
Also, reenable NFS exporting.
board versions with no BIOS. Separate mailbox interrupts from
IOCB interrupts. Read OUTMAILBOX5 while RISC_INT is active- not
after you clear it (potential race condition). Clear out older broken
BIG_ENDIAN goop. Don't negotiate narrow/async for LVD busses at startup
if already in LVD mode. Note usage of presumptive 1040C revision. For
all the LIP, PDB Changed, Loop UP/DOWN async events, mark fw state
as unknown as well as marking the need to do a getpdb on targets- after
a LIP for certain the f/w has to do PRLI/PLOGI for all targets again
and marking f/w state as unknown gives us a fighting chance to (start
to) hold up for that to complete.
that will SBusify an isp header or the lun/target portions of a request IOCB-
and have these only valid iff __sparc__ (no non-sparc SBus machine that *I*
know about).
remote of the tunnel can be found.
XXX If you manually mark the interface as "UP" and set the MTU later
XXX sending a packet will still cause a kernel panic.
was deasserted and we wanted to change parameters to -crtscts
This effectively stalled the transmitter since with TS_BUSY set
we only change parameters during the Tx interrupt handler.
passing SIOCSIFADDR/SIOIFDSTADDR, but by passing the addresses in
the appropriate structs.
One of the mysteries of ifconfig IMHO...
Should fix kern/6899.
provides the correct functions for primary, secondary, and unified
boot blocks. actually behave correctly (e.g. expect correct arguments,
perform correct operations) depending on which you are. also
some minor cleanup.
guts were actually functionally equivalent to the current guts, but were
much larger, filled with bugs, and indeed poked around at the disklabel
when some of those bugs prevented them from ever using the disklabel!
had a few bugs fixed that let the problem slip in, and since bootxx's
Makefile now goes out of its way to satisfy installboot's undocumented
and totally unreasonable assumptions about the bootxx file it's operating
on. No point in fixing the assumptions, because sooner rather than later
this incarnation of installboot is going to die.
assuming that there's always going to be space for the whole boot
block info struct. (the assumption would cause a malloc'd region
to be overrun, if it proved false.)
are called from the interrupt or timeout handler, 0 otherwise.
- use this to know if we can busy-wait for wait_for_unbusy or wait_for_ready
This fixes a bug where CDs withot the DRQ_INTR capability would not busy-wait
for the CMDOUT phase.
While I'm there change 2 delay() to DELAY() for consistency, and
garbage-collect some old code from wdcintr() which has been ifdef'd out
for some time now.
TULIP_BUSMODE_BIGENDIAN does bswap packet buffers also, so we should use
TULIP_BUSMODE_DESC_BIGENDIAN on big-endian machines. (PR 7027)
XXX 21040 doesn't have this bit, but supporting only 21041+ is better than
nothing.
picking the bits we wanted explicitly, taking advantage of some of the
recent code-size trimming from cgd. There's now no duplication if libsa
code in sys/arch/pmax/stand.
As a bonus, we now have 416 bytes free in stage one (up from 80), and
will all of Chris' space saving options enabled (these are commented out
in scsiboot/Makefile), theres over a 1kB free.
perry