'inline' as well as static. mark prototypes for static inline functions
as possibly unused (with __attribute__ ((unused))), to avoid generating
warnings when compiling without optimization but with most ports'
default warning flags. Clean up prototype list spacing, and make it more
consistent.
connect to their 1-wire bus like the DS2404 "EconoRAM Time Chip"
- and -
* Interface function definitions for this kind of chips. Currently only
low-level byte_read and _write, implenented as inline functions.
This functions take a struct ds_handle * (also defined here), which contains
pointers to bit-read/write and reset functions.
Eventually, prototypes for memory-access functions should go here, and the
1-wire bus should be made a BSD auto-configuration bus.
(a) The interrupt is a RESEL interrupt, and
(b) our state is SELECTING.
This condition can occur in perfectly normal operation if we are using
DMA to select the target and we are interrupted by another target
reselecting us. Per discussion with Paul Krannenburg.
Every ccb locks 64k of memory for dma buffers.
Instead of AHA_CCB_MAX ccbs using 1MByte only sc_link.openings ccbs
per device are allocated. Thus we now use only 128KByte per device present.
clock rate for this board on Alpha/PCI systems. Under x86/PCI, the
board f/w will correctly tell you "I'm running at 60Mhz", so the code
that preserved that across a board reset (which would drop the chip
back to 40Mhz) worked fine. On the 8200, the chip was saying "I'm 40Mhz"-
which wasn't true. This turned out to be okay as long as you didn't have
any FAST or UltraFast targets- In fact, setting the chip to 40Mhz allowed
you to run up to 8Mhz SCSI. Unfortunately you die bigtime on the devices
that go faster than that. The fix here is to only use what the chip tells
you the clock rate is in the cases you don't really know (sbus is the
only case where this could be different, although with 66Mhz PCI coming up,
this may change).
(1) fix a printf format (%x to print int, not %lx).
(2) fix probe of 4th chip/16th channel (used to tell whether or not the
board is a 16- or 32-port board) by removing an incorrect offset so
that the code matched its comments. (!!!)
(3) fix storage of chip number in per-channel structure so that it actually
stores the chip number, rather than the chip offset. This allows the
driver to work with more than the first four channels (i.e. with chips
other than chip number 0, which happens to have an offset of zero). (!!!)
MESSAGE_REJECT in response to SDTR or WDTR. Because of this, the
printfs that indicate refusal of sync/wide negotiation are unneeded
in normal operation. In the __NetBSD__ case, disable them by default.
They, like the other extra-verbose ahc driver boot messages, may be
reenabled with "options DEBUG". The behavior in the !__NetBSD__ case
is unchanged.
Set the encoding parameters slightly differently.
Remove the SW encoding/decodinf functions from this interface
and move them to the audio_parameter struct; this is both more efficient
and flexible.
This allows the front end to override the default DCR (byte-wide DMA,
x86 byte order, 8-byte FIFO) with different transfer size, byte order, DMA
parameters, and FIFO threshhold. If the loopback select bit is not set for
normal operation, the default is used instead.
Inspired by thoughts from Bernd Ernesti.
* epinit() had both explicit xcvr selection for 3c589 and a call
to epsetmedia(). The first is redundant; delete it, and EP_COAX_DEFAULT.
* Update comments to reflect 3c589 and 3c509B fixes. Fix typos.