position, see if there is a failed component still hanging around that
we can use instead (but still mark it as failed). This leads to more
reasonable behaviour (and fewer surprises!) when autoconfiguring and
failed (or previously failed) components are still on the system.
- Change the transmit logic to send from a pre-allocated buffer instead
of doing DMA out of the mbufs directly. Timing shows that it takes
4 times longer to map in the mbufs via the sgmap routines instead of
just copying the data! This must be fixed sometine in the future.
- A bunch of other minor fixes.
FIOASYNC ioctrl command had been forwarded from wsmux to each mouse devices
and the devices had set their own event queue async mode. But no one had took
care of the event queue's mode of wsmux itself. Wsmux should make it's own
event queue async mode when it receive FIOASYNC command.
and QUEUE FULL cases; this is already done for all BAD_STATUS cases.
Make sure to requeue the SCB in the above cases internally in the driver,
the SCSI layer doesn't know how to deal with it properly.
some devices may not be found if the BIOS (which would normally
do the reset at startup) is disabled. Should really be done from the SCSI
layer.
Implement the SCBUSIORESET ioctl.
renegades, and must be handled correctly. In particular, they should
be added to their old auto-config set, but then immediately released.
Failing to do otherwise means that they potentialy end up in a
different (and competing!) RAID set which may auto-configure in place
of the correct one, and cause all sorts of chaos at auto-configure
time.
This bug is only visible on some disks, and I have verified that it works
correctly on VAX. However, du to the author, it is a problem on other
machines/disks as well. Here's the author's comments:
> The MI code for the NCR5380 has a small bug in it The RZ56 wants to
> negotiate for Synchronous Data Transfers and when it does, the current code
> looks like it will send a REJECT message as the spec calls for when we cant
> handle the request. However, a couple of lines of code in the
> ncr5380_msg_in routine are missing wrt the PARITY message and anything that
> wants to send a REJECT message. The ATN setup that is done in
> ncr_sched_msgout is immediately negated by the final byte ACK sequence in
> this routine. This causes bad things to happen to an RZ56.
re-enqueueing an already free ccb.
Prepare the background to have a unique initialization function for
all of the supported host adapters.
Rename a lot of #define in a more sane way.
Move Carriers initialization and defines in adwmcode.{c,h}
Don't lose Carrier nodes in case of a BUS/Chip reset explicitly invoked
after a DMA failure.
XXX - DMA failure still arise when AdvanSys U[2]W host adapters are used
in conjunction with Intel 82443BX Host Bridge/Controller (rev. 0x03).
!?!Have to understand why!?!
oster