NetBSD/distrib/notes/i386/hardware

NetBSD/i386 1.1 runs on ISA (AT-Bus), EISA, PCI, and VL-bus systems
with 386-family processors, with or without math coprocessors.  It
does NOT support MCA systems, such as some IBM PS/2 systems.  The
minimal configuration is said to require 4M of RAM and 50M of disk space,
though we do not know of anyone running with a system quite this minimal today.
To install the entire system requires much more disk space, and to run X
or compile the system, more RAM is recommended.  (4M of RAM will
actually allow you to run X and/or compile, but it won't be speedy.
Note that until you have around 16M of RAM, getting more RAM is more
important than getting a faster CPU.)

Supported devices include:
	Floppy controllers.
	MFM, ESDI, IDE, and RLL hard disk controllers.
	SCSI host adapters:
			[Adaptec host adapters only on kcadp floppy]
		Adaptec AHA-154xA, -B, -C, and -CF 
		Adaptec AHA-174x
		Adaptec AIC-6260 and AIC-6360 based boards, including
			the Adaptec AHA-152x and the SoundBlaster SCSI
			host adapter.  (Note that you cannot boot from
			these boards if they do not have a boot ROM;
			only the AHA-152x and motherboards using this chip
			are likely to be bootable, consequently.)
		Adaptec AHA-294x[W] cards and some onboard PCI designs using
			the AIC7870 chip.  This driver does *not* currently
			work with non-PCI AIC-7xxx boards or the Adaptec 3940.
		Buslogic 54x (Adaptec AHA-154x clones; driver on kcadp floppy)

			[Other host adapters only on kcoth floppy]
		BusLogic 445, 74x, 9xx  (But not the new "FlashPoint" series
			of BusLogic SCSI adapters)
		Symbios Logic (NCR) 53C8xx-based PCI SCSI host adapters
		Ultrastor 14f, 34f, and (possibly) 24f
		Seagate/Future Domain ISA SCSI adapter cards, including
			ST01/02
			Future Domain TMC-885
			Future Domain TMC-950

	MDA, CGA, VGA, SVGA, and HGC Display Adapters.  (Note that not
		all of the display adapters NetBSD/i386 can work with
		are supported by X.  See the XFree86 FAQ for more
		information.)
	Serial ports:
		8250/16450-based ports
		16550-based ports
		AST-style 4-port serial boards [*]
		BOCA 8-port serial cards [*] 
		Cyclades Cyclom-{4, 8, 16}Y serial boards [*]
		IBM PC-RT 4-port serial boards [*]
	Parallel ports.
	Ethernet adapters:
		AMD LANCE and PCnet-based ISA Ethernet adapters [*], including:
			Novell NE1500T
			Novell NE2100
			Kingston 21xx
		AMD PCnet-based PCI Ethernet adapters, including:
			BOCALANcard/PCI
		AT&T StarLAN 10, EN100, and StarLAN Fiber
		3COM 3c501
		3COM 3c503
		3COM 3c505 [*]
		3COM 3c507
		3COM 3c509 and 3c579 (But not the PCI 3c59X series)
		Digital DC21x4x-based PCI Ethernet adapters, including:
			SMC EtherPower 10, 10/100 (PCI only!)
			Znyx ZX34X
			Cogent EM100
			Digital DE450
			Digital DE500
		BICC Isolan [* and not recently tested]
		Intel EtherExpress 16
		SMC/WD 8003, 8013, and the SMC "Elite16" ISA boards
		SMC/WD 8216 (the SMC "Elite16 Ultra" ISA boards)
		Novell NE1000, NE2000
	Tape drives:
		Most SCSI tape drives
		QIC-02 and QIC-36 format (Archive- and Wangtek-
			compatible) tape drives [*] [+]
	CD-ROM drives:
		Mitsumi CD-ROM drives [*] [+]
			[Note: The Mitsumi driver device probe is known 
			to cause trouble with several devices!]
		Most SCSI CD-ROM drives
	Mice:
		"Logitech"-style bus mice [*] [+]
		"Microsoft"-style bus mice [*] [+]
		"PS/2"-style mice [*] [+]
		Serial mice (no kernel support necessary)
	Sound Cards:
		SoundBlaster [*] [+]
		Gravis Ulrasound and Ultrasound Max [*] [+]
			[The following drivers are not extensively tested]
		Personal Sound System [*] [+]
		Windows Sound System [*] [+]
		ProAudio Spectrum [*] [+]
	Miscellaneous:

Drivers for hardware marked with "[*]" are NOT included on the
distribution floppies.  Except as noted above, all other drivers are
present on both kernel-copy disks.  Also, at the present time, the
distributed kernels support only one SCSI host adapter per machine.
NetBSD normally allows more, though, so if you have more than one, you
can use all of them by compiling a custom kernel once NetBSD is
installed.

Support for devices marked with "[+]" IS included in the "generic" kernels,
although it is not in the kernels which are on the distribution floppies.


Hardware the we do NOT currently support, but get many questions
about:
	Adaptec AIC-7770-based SCSI host adapters (including the
		Adaptec AHA-274x, AHA-284x families).
	NCR 5380-based SCSI host adapters.
	APM power management -- if your system supports it, turn it off!
	PCMCIA ("PC Card") devices, including some miniature "IDE" hard disks.
	QIC-40 and QIC-80 tape drives.  (Those are the tape drives
		that connect to the floppy disk controller.)
	WD-7000 SCSI host adapters.
	PCI-PCI bridges and cards which include them, such as the AHA-394x
		SCSI host adapter and some DC21x4x-based multi-Ethernet cards.
	3Com 3c59x series PCI Ethernet and Fast Ethernet adapters.
	Multiprocessor Pentium and Pentium Pro systems.  (Though they should
		run fine using one processor only.)
	Intel EtherExpress 100 Fast Ethernet adapters.
	Digital DEFPA PCI FDDI adapters (support barely missed this release;
		it works in other ports, and will work in this one in the
		next release)

We are planning future support for many of these devices.

To be detected by the distributed kernels, the devices must
be configured as follows:

Device		Name	Port	IRQ	DRQ	Misc
------		----	----	---	---	----
Serial ports	com0	0x3f8	4		[8250/16450/16550/clones]
		com1	0x2f8	3		[8250/16450/16550/clones]
		com2	0x3e8	5		[8250/16450/16550/clones]

Parallel ports	lpt0	0x378	7		[interrupt-driven or polling]
		lpt1	0x278			[polling only]
		lpt2	0x3bc			[polling only]

MFM/ESDI/IDE/RLL hard disk controller
		wdc0	0x1f0	14		[supports two disks]

Floppy controller
		fdc0	0x3f0	6	2	[supports two disks]

AHA-154x, AHA-174x (in compatibility mode), or BT-54x SCSI host adapters
		aha0	0x330	any	any	[only on kcadp kernel floppy]

AHA-174x SCSI host adapters (in enhanced mode)
		ahb0	any	any	any	[only on kcadp kernel floppy]

BT445, BT74x, or BT9xx SCSI host adapters
		bt0	0x330	any	any	[only on kcoth kernel floppy]

Ultrastor 14f, 24f (if it works), or 34f SCSI host adapters
		uha0	0x330	any	any	[only on kcoth kernel floppy]

AHA-152x, AIC-6260- or AIC-6360-based SCSI host adapters
		aic0	0x340	11	6	[only on kcadp kernel floppy]

Symbios Logic/NCR 53C8xx based PCI SCSI host adapters
		ncr0	any	any	any	[only on kcoth kernel floppy]

SCSI disks	sd0	first SCSI disk (by SCSI id)
		sd1	second SCSI disk (by SCSI id)
		sd2	third SCSI disk (by SCSI id)
		sd3	fourth SCSI disk (by SCSI id)

SCSI tapes	st0	first SCSI tape (by SCSI id)
		st1	second SCSI tape (by SCSI id)

SCSI CD-ROMs	cd0	first SCSI CD-ROM (by SCSI id)
		cd1	second SCSI CD-ROM (by SCSI id)

SMC/WD 8003, 8013, Elite16, and Elite16 Ultra Ethernet boards, 3c503,
Novell NE1000, or NE2000 Ethernet boards
		ed0	0x280	2		iomem 0xd0000
		ed1	0x250	2		iomem 0xd8000
		ed2	0x300	10		iomem 0xcc000

3COM 3c509 or 3COM 3c579 Ethernet boards
		ep0	any	any

AT&T StarLAN 10, EN100, or StarLAN Fiber, or 3COM 3c507 Ethernet boards
		ie0	0x360	7		iomem 0xd0000

PCNet-PCI based Ethernet boards; see above for partial list
		le0	any	any	[you must assign an interrupt in your
					 PCI BIOS, or let it do so for you]

DC21x4x based Ethernet boards; see above for partial list
		de0	any	any 	[you must assign an interrupt in your
					 PCI BIOS, or let it do so for you]