NetBSD/sys/arch/sparc/sbus/dmareg.h

136 lines
6.2 KiB
C
Raw Normal View History

/*
* Copyright (c) 1992, 1993
* The Regents of the University of California. All rights reserved.
*
* This software was developed by the Computer Systems Engineering group
* at Lawrence Berkeley Laboratory under DARPA contract BG 91-66 and
* contributed to Berkeley.
*
* All advertising materials mentioning features or use of this software
* must display the following acknowledgement:
* This product includes software developed by the University of
* California, Lawrence Berkeley Laboratory.
*
* Redistribution and use in source and binary forms, with or without
* modification, are permitted provided that the following conditions
* are met:
* 1. Redistributions of source code must retain the above copyright
* notice, this list of conditions and the following disclaimer.
* 2. Redistributions in binary form must reproduce the above copyright
* notice, this list of conditions and the following disclaimer in the
* documentation and/or other materials provided with the distribution.
* 3. All advertising materials mentioning features or use of this software
* must display the following acknowledgement:
* This product includes software developed by the University of
* California, Berkeley and its contributors.
* 4. Neither the name of the University nor the names of its contributors
* may be used to endorse or promote products derived from this software
* without specific prior written permission.
*
* THIS SOFTWARE IS PROVIDED BY THE REGENTS AND CONTRIBUTORS ``AS IS'' AND
* ANY EXPRESS OR IMPLIED WARRANTIES, INCLUDING, BUT NOT LIMITED TO, THE
* IMPLIED WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE
* ARE DISCLAIMED. IN NO EVENT SHALL THE REGENTS OR CONTRIBUTORS BE LIABLE
* FOR ANY DIRECT, INDIRECT, INCIDENTAL, SPECIAL, EXEMPLARY, OR CONSEQUENTIAL
* DAMAGES (INCLUDING, BUT NOT LIMITED TO, PROCUREMENT OF SUBSTITUTE GOODS
* OR SERVICES; LOSS OF USE, DATA, OR PROFITS; OR BUSINESS INTERRUPTION)
* HOWEVER CAUSED AND ON ANY THEORY OF LIABILITY, WHETHER IN CONTRACT, STRICT
* LIABILITY, OR TORT (INCLUDING NEGLIGENCE OR OTHERWISE) ARISING IN ANY WAY
* OUT OF THE USE OF THIS SOFTWARE, EVEN IF ADVISED OF THE POSSIBILITY OF
* SUCH DAMAGE.
*
* @(#)dmareg.h 8.1 (Berkeley) 6/11/93
*
* from: Header: dmareg.h,v 1.6 93/04/27 14:39:17 torek Exp (LBL)
* $Id: dmareg.h,v 1.1 1993/10/02 10:23:49 deraadt Exp $
*/
/*
* Sun-4c Sbus slot 0 DMA registers.
*
* Note that the dma_addr on the rev 1 gate array cannot increment
* across a 16 MB boundary (the counter is only 24 bits wide; the
* top 8 bits are simply latched).
*/
struct dmareg {
u_long dma_csr; /* control/status register */
u_long dma_addr; /* address (virtual: is fed to MMU) */
u_long dma_bc; /* byte count (not used) */
u_long dma_diag; /* diagnostic register (not used) */
};
/*
* Bits in dma_csr.
* DMA chip revision numbers are confusing (rev 3 = `DMA2'?!).
* Not my fault; we just live with what they give us....
*
* Notes in [brackets]:
* 1: used this way in rev 1 (`DMA') chips.
* 2: used this way in rev 2 (`DMA+') chips.
* 3: used this way in rev 3 (`DMA2') chips.
* R: not self-clearing, must be reset after being set.
* D: `drain' is like Unibus `bdp purge', i.e., it tells
* the chip to finish up, because there is no more data
* going into the buffer register. Supposed to be needed
* only in rev 1, but apparently needed or harmless in all
* revs. Self-clearing (hence write-only).
* I: also enables scsi interrupts.
*/
#define DMA_REV(csr) (((csr) >> 28) & 0xf) /* device id field */
#define DMAREV_1 0x8 /* rev 1 DMA gate array */
#define DMAREV_2 0x9 /* rev 2 DMA gate array (`DMA+') */
#define DMAREV_3 0xa /* rev 3 DMA gate array (`DMA2') */
#define DMA_1ZERO 0x0fff0000 /* unused; reads as zero [1] */
#define DMA_NAL 0x08000000 /* next address loaded [2] (ro) */
#define DMA_AL 0x04000000 /* address loaded [2] (ro) */
#define DMA_ON 0x02000000 /* working [2] (ro) */
#define DMA_NAE 0x01000000 /* next-address enable [2] (rw) */
#define DMA_DTCI 0x00800000 /* disable DMA_TC intr [2] (rw) */
#define DMA_TURBO 0x00400000 /* faster 53C90A mode [2] (rw) */
#define DMA_LERR 0x00200000 /* LANCE error [2] (ro) */
#define DMA_TWOCYCLE 0x00200000 /* two cycle mode [3] (rw?) */
#define DMA_ALE 0x00100000 /* LANCE addr latch ena [2] (rw) */
#define DMA_2ZERO 0x000f0000 /* unused; reads as zero [2] */
#define DMA_BURSTMASK 0x000c0000 /* burst mode mask [3] */
#define DMA_BURST16 0x00000000 /* 16-byte bursts (default) */
#define DMA_BURST32 0x00040000 /* 32-byte bursts */
#define DMA_BURST0 0x00080000 /* no bursts */
#define DMA_ILACC 0x00008000 /* for new AMD ethernet chip [1,2] */
#define DMA_TC 0x00004000 /* terminal cnt: dma_bc ran out [1,2] */
#define DMA_BCE 0x00002000 /* byte count enable (leave 0) */
#define DMA_BO 0x00001800 /* byte offset [1] (ro) */
#define DMA_RP 0x00000400 /* busy, plz don't flush [1] (ro) */
#define DMA_ENA 0x00000200 /* enable the dma chip */
#define DMA_READ 0x00000100 /* set for dev=>mem, i.e., read() */
#define DMA_RESET 0x00000080 /* reset dma chip [R] */
#define DMA_DRAIN 0x00000040 /* drain buffered data [D,1] (wo) */
#define DMA_SLAVEERR 0x00000040 /* slave error [2,3] (ro) */
#define DMA_FLUSH 0x00000020 /* clear PC, EP, and TC [2,3] (wo) */
#define DMA_IE 0x00000010 /* interrupt enable [2,3,I] */
#define DMA_PC 0x0000000c /* bytes in pack reg [1] (ro) */
#define DMA_DRAINING 0x0000000c /* nonzero => draining [2,3] (ro) */
#define DMA_EP 0x00000002 /* error pending (ro) */
#define DMA_IP 0x00000001 /* interrupt pending (ro) */
#define DMA_REV1_BITS \
"\20\20ILACC\17TC\16BCE\13RP\12ENA\11READ\10RESET\7DRAIN\2EP\1IP"
/* Look ma, second system syndrome! */
#define DMA_REV2_BITS \
"\20\34NAL\33AL\32ON\31NAE\30DTCI\27TURBO\26LERR\25ALE\
\20ILACC\17TC\16BCE\12ENA\11READ\10RESET\7SLAVEERR\6FLUSH\5IE\2EP\1IP"
/* (Note how most of the crap has been discarded now.) */
#define DMA_REV3_BITS \
"\20\26TWOCYCLE\16BCE\12ENA\11READ\10RESET\7SLAVEERR\6FLUSH\5IE\2EP\1IP"
/* DMA_BYTE turns the DMA_BO field into a byte index */
#define DMA_BYTE(csr) (((csr) >> 11) & 3)
/* DMA_NPACK turns the DMA_PC field into a byte count */
#define DMA_NPACK(csr) (((csr) >> 2) & 3)
/* DMA_INTR is true if the DMA chip says an ESP or DMA interrupt is pending */
#define DMA_INTR(csr) ((csr) & (DMA_IP | DMA_EP))