NetBSD/sys/arch/sparc/dev/sireg.h

128 lines
4.2 KiB
C
Raw Normal View History

/* $NetBSD: sireg.h,v 1.3 1996/01/01 22:40:58 thorpej Exp $ */
/*
* Register map for the Sun3 SCSI Interface (si)
* The first part of this register map is an NCR5380
* SCSI Bus Interface Controller (SBIC). The rest is a
* DMA controller and custom logic in one of two flavors,
* one for the OBIO interface (3/50,3/60) and one for the
* VME interface (3/160,3/260,etc.), where some registers
* are implemented only on one or the other, some on both.
*
* Modified for Sun 4 systems by Jason R. Thorpe <thorpej@NetBSD.ORG>.
*/
/*
* Note that the obio version on the 4/1xx (the so-called "SCSI Weird", or
* "sw" controller) is laid out a bit differently, and hence the evilness
* with unions. Also, the "sw" doesn't appear to have a FIFO.
*/
/*
* Am5380 Register map (no padding)
*/
struct ncr5380regs {
volatile u_char sci_r0;
volatile u_char sci_r1;
volatile u_char sci_r2;
volatile u_char sci_r3;
volatile u_char sci_r4;
volatile u_char sci_r5;
volatile u_char sci_r6;
volatile u_char sci_r7;
};
struct si_regs {
struct ncr5380regs sci;
/* DMA controller registers */
union {
struct {
u_short _Dma_addrh; /* dma address (VME only) */
u_short _Dma_addrl; /* (high word, low word) */
} _si_u1_s;
u_int _Dma_addr; /* dma address (OBIO) */
} _si_u1;
#define dma_addrh _si_u1._si_u1_s._Dma_addrh
#define dma_addrl _si_u1._si_u1_s._Dma_addrl
#define dma_addr _si_u1._Dma_addr
union {
struct {
u_short _Dma_counth; /* dma count (VME only) */
u_short _Dma_countl; /* (high word, low word) */
} _si_u2_s;
u_int _Dma_count; /* dma count (OBIO) */
} _si_u2;
#define dma_counth _si_u2._si_u2_s._Dma_counth
#define dma_countl _si_u2._si_u2_s._Dma_countl
#define dma_count _si_u2._Dma_count
u_int si_pad0; /* no-existent register */
union {
struct {
u_short _Fifo_data; /* fifo data register */
u_short _Fifo_count; /* fifo count register */
} _si_u4_s;
u_int _Sw_csr; /* sw control/status */
} _si_u4;
#define fifo_data _si_u4._si_u4_s._Fifo_data
#define fifo_count _si_u4._si_u4_s._Fifo_count
#define sw_csr _si_u4._Sw_csr
union {
struct {
u_short _Si_csr; /* si control/status */
u_short _Bprh; /* VME byte pack high */
} _si_u5_s;
u_int _Bpr; /* sw byte pack */
} _si_u5;
#define si_csr _si_u5._si_u5_s._Si_csr
#define si_bprh _si_u5._si_u5_s._Bprh
#define sw_bpr _si_u5._Bpr
/* The rest of these are on the VME interface only: */
u_short si_bprl; /* VME byte pack low */
u_short si_iv_am; /* bits 0-7: intr vector */
/* bits 8-13: addr modifier (VME only) */
/* bits 14-15: unused */
u_short fifo_cnt_hi; /* high part of fifo_count (VME only) */
/* Whole thing repeats after 32 bytes. */
u_short _space[3];
};
/* possible values for the address modifier, vme version only */
#define VME_SUPV_DATA_24 0x3d00
/*
* Status Register.
* Note:
* (r) indicates bit is read only.
* (rw) indicates bit is read or write.
* (v) vme host adaptor interface only.
* (o) sun3/50 onboard host adaptor interface only.
* (b) both vme and sun3/50 host adaptor interfaces.
*/
#define SI_CSR_DMA_ACTIVE 0x8000 /* (r,o) dma transfer active */
#define SI_CSR_DMA_CONFLICT 0x4000 /* (r,b) reg accessed while dmaing */
#define SI_CSR_DMA_BUS_ERR 0x2000 /* (r,b) bus error during dma */
#define SI_CSR_ID 0x1000 /* (r,b) 0 for 3/50, 1 for SCSI-3, */
/* 0 if SCSI-3 unmodified */
#define SI_CSR_FIFO_FULL 0x0800 /* (r,b) fifo full */
#define SI_CSR_FIFO_EMPTY 0x0400 /* (r,b) fifo empty */
#define SI_CSR_SBC_IP 0x0200 /* (r,b) sbc interrupt pending */
#define SI_CSR_DMA_IP 0x0100 /* (r,b) dma interrupt pending */
#define SI_CSR_LOB 0x00c0 /* (r,v) number of leftover bytes */
#define SI_CSR_LOB_THREE 0x00c0 /* (r,v) three leftover bytes */
#define SI_CSR_LOB_TWO 0x0080 /* (r,v) two leftover bytes */
#define SI_CSR_LOB_ONE 0x0040 /* (r,v) one leftover byte */
#define SI_CSR_BPCON 0x0020 /* (rw,v) byte packing control */
/* dma is in 0=longwords, 1=words */
#define SI_CSR_DMA_EN 0x0010 /* (rw,v) dma/interrupt enable */
#define SI_CSR_SEND 0x0008 /* (rw,b) dma dir, 1=to device */
#define SI_CSR_INTR_EN 0x0004 /* (rw,b) interrupts enable */
#define SI_CSR_FIFO_RES 0x0002 /* (rw,b) inits fifo, 0=reset */
#define SI_CSR_SCSI_RES 0x0001 /* (rw,b) reset sbc and udc, 0=reset */