NetBSD/sys/dev/isa/ahareg.h

267 lines
6.5 KiB
C
Raw Normal View History

typedef u_int8_t physaddr[3];
typedef u_int8_t physlen[3];
#define ltophys _lto3b
#define phystol _3btol
/*
* I/O port offsets
*/
#define AHA_CTRL_PORT 0 /* control (wo) */
#define AHA_STAT_PORT 0 /* status (ro) */
#define AHA_CMD_PORT 1 /* command (wo) */
#define AHA_DATA_PORT 1 /* data (ro) */
#define AHA_INTR_PORT 2 /* interrupt status (ro) */
/*
* AHA_CTRL bits
*/
#define AHA_CTRL_HRST 0x80 /* Hardware reset */
#define AHA_CTRL_SRST 0x40 /* Software reset */
#define AHA_CTRL_IRST 0x20 /* Interrupt reset */
#define AHA_CTRL_SCRST 0x10 /* SCSI bus reset */
/*
* AHA_STAT bits
*/
#define AHA_STAT_STST 0x80 /* Self test in Progress */
#define AHA_STAT_DIAGF 0x40 /* Diagnostic Failure */
#define AHA_STAT_INIT 0x20 /* Mbx Init required */
#define AHA_STAT_IDLE 0x10 /* Host Adapter Idle */
#define AHA_STAT_CDF 0x08 /* cmd/data out port full */
#define AHA_STAT_DF 0x04 /* Data in port full */
#define AHA_STAT_INVDCMD 0x01 /* Invalid command */
/*
* AHA_CMD opcodes
*/
#define AHA_NOP 0x00 /* No operation */
#define AHA_MBX_INIT 0x01 /* Mbx initialization */
#define AHA_START_SCSI 0x02 /* start scsi command */
#define AHA_INQUIRE_REVISION 0x04 /* Adapter Inquiry */
#define AHA_MBO_INTR_EN 0x05 /* Enable MBO available interrupt */
1996-04-30 00:02:32 +04:00
#if 0
#define AHA_SEL_TIMEOUT_SET 0x06 /* set selection time-out */
#define AHA_BUS_ON_TIME_SET 0x07 /* set bus-on time */
#define AHA_BUS_OFF_TIME_SET 0x08 /* set bus-off time */
#define AHA_SPEED_SET 0x09 /* set transfer speed */
#endif
#define AHA_INQUIRE_DEVICES 0x0a /* return installed devices 0-7 */
#define AHA_INQUIRE_CONFIG 0x0b /* return configuration data */
#define AHA_TARGET_EN 0x0c /* enable target mode */
#define AHA_INQUIRE_SETUP 0x0d /* return setup data */
#define AHA_ECHO 0x1e /* Echo command data */
#define AHA_INQUIRE_DEVICES_2 0x23 /* return installed devices 8-15 */
#define AHA_EXT_BIOS 0x28 /* return extended bios info */
#define AHA_MBX_ENABLE 0x29 /* enable mail box interface */
/*
* AHA_INTR bits
*/
#define AHA_INTR_ANYINTR 0x80 /* Any interrupt */
#define AHA_INTR_SCRD 0x08 /* SCSI reset detected */
#define AHA_INTR_HACC 0x04 /* Command complete */
#define AHA_INTR_MBOA 0x02 /* MBX out empty */
#define AHA_INTR_MBIF 0x01 /* MBX in full */
struct aha_mbx_out {
u_char cmd;
physaddr ccb_addr;
};
struct aha_mbx_in {
u_char stat;
physaddr ccb_addr;
};
/*
* mbo.cmd values
*/
#define AHA_MBO_FREE 0x0 /* MBO entry is free */
#define AHA_MBO_START 0x1 /* MBO activate entry */
#define AHA_MBO_ABORT 0x2 /* MBO abort entry */
/*
* mbi.stat values
*/
#define AHA_MBI_FREE 0x0 /* MBI entry is free */
#define AHA_MBI_OK 0x1 /* completed without error */
#define AHA_MBI_ABORT 0x2 /* aborted ccb */
#define AHA_MBI_UNKNOWN 0x3 /* Tried to abort invalid CCB */
#define AHA_MBI_ERROR 0x4 /* Completed with error */
/* FOR OLD VERSIONS OF THE !%$@ this may have to be 16 (yuk) */
#define AHA_NSEG 17 /* Number of scatter gather segments <= 16 */
/* allow 64 K i/o (min) */
struct aha_scat_gath {
physlen seg_len;
physaddr seg_addr;
};
struct aha_ccb {
u_char opcode;
u_char lun:3;
u_char data_in:1; /* must be 0 */
u_char data_out:1; /* must be 0 */
u_char target:3;
u_char scsi_cmd_length;
u_char req_sense_length;
physlen data_length;
physaddr data_addr;
physaddr link_addr;
u_char link_id;
u_char host_stat;
u_char target_stat;
u_char reserved[2];
struct scsi_generic scsi_cmd;
struct scsi_sense_data scsi_sense;
struct aha_scat_gath scat_gath[AHA_NSEG];
/*----------------------------------------------------------------*/
TAILQ_ENTRY(aha_ccb) chain;
struct aha_ccb *nexthash;
long hashkey;
struct scsi_xfer *xs; /* the scsi_xfer for this cmd */
int flags;
#define CCB_ALLOC 0x01
#define CCB_ABORT 0x02
#ifdef AHADIAG
#define CCB_SENDING 0x04
#endif
int timeout;
};
/*
* opcode fields
*/
#define AHA_INITIATOR_CCB 0x00 /* SCSI Initiator CCB */
#define AHA_TARGET_CCB 0x01 /* SCSI Target CCB */
#define AHA_INIT_SCAT_GATH_CCB 0x02 /* SCSI Initiator with scatter gather */
#define AHA_RESET_CCB 0x81 /* SCSI Bus reset */
/*
* aha_ccb.host_stat values
*/
#define AHA_OK 0x00 /* cmd ok */
#define AHA_LINK_OK 0x0a /* Link cmd ok */
#define AHA_LINK_IT 0x0b /* Link cmd ok + int */
#define AHA_SEL_TIMEOUT 0x11 /* Selection time out */
#define AHA_OVER_UNDER 0x12 /* Data over/under run */
#define AHA_BUS_FREE 0x13 /* Bus dropped at unexpected time */
#define AHA_INV_BUS 0x14 /* Invalid bus phase/sequence */
#define AHA_BAD_MBO 0x15 /* Incorrect MBO cmd */
#define AHA_BAD_CCB 0x16 /* Incorrect ccb opcode */
#define AHA_BAD_LINK 0x17 /* Not same values of LUN for links */
#define AHA_INV_TARGET 0x18 /* Invalid target direction */
#define AHA_CCB_DUP 0x19 /* Duplicate CCB received */
#define AHA_INV_CCB 0x1a /* Invalid CCB or segment list */
struct aha_revision {
struct {
u_char opcode;
} cmd;
struct {
u_char boardid; /* type of board */
/* 0x31 = AHA-1540 */
/* 0x41 = AHA-1540A/1542A/1542B */
/* 0x42 = AHA-1640 */
/* 0x43 = AHA-1542C */
/* 0x44 = AHA-1542CF */
/* 0x45 = AHA-1542CF, BIOS v2.01 */
/* 0x46 = AHA-1542CP */
u_char spec_opts; /* special options ID */
/* 0x41 = Board is standard model */
u_char revision_1; /* firmware revision [0-9A-Z] */
u_char revision_2; /* firmware revision [0-9A-Z] */
} reply;
};
struct aha_extbios {
struct {
u_char opcode;
} cmd;
struct {
u_char flags; /* Bit 3 == 1 extended bios enabled */
u_char mailboxlock; /* mail box lock code to unlock it */
} reply;
};
struct aha_toggle {
struct {
u_char opcode;
u_char enable;
} cmd;
};
struct aha_config {
struct {
u_char opcode;
} cmd;
struct {
u_char chan;
u_char intr;
u_char scsi_dev:3;
u_char :5;
} reply;
};
struct aha_mailbox {
struct {
u_char opcode;
u_char nmbx;
physaddr addr;
} cmd;
};
struct aha_unlock {
struct {
u_char opcode;
u_char junk;
u_char magic;
} cmd;
};
struct aha_devices {
struct {
u_char opcode;
} cmd;
struct {
u_char junk[8];
} reply;
};
struct aha_setup {
struct {
u_char opcode;
u_char len;
} cmd;
struct {
u_char sync_neg:1;
u_char parity:1;
u_char :6;
u_char speed;
u_char bus_on;
u_char bus_off;
u_char num_mbx;
u_char mbx[3];
struct {
u_char offset:4;
u_char period:3;
u_char valid:1;
} sync[8];
u_char disc_sts;
} reply;
};
#define INT9 0x01
#define INT10 0x02
#define INT11 0x04
#define INT12 0x08
#define INT14 0x20
#define INT15 0x40
#define EISADMA 0x00
#define CHAN0 0x01
#define CHAN5 0x20
#define CHAN6 0x40
#define CHAN7 0x80